diff mbox series

[04/10] clk: qcom: gcc-sc8180x: Add missing USB MP resets

Message ID 20240525-sc8180x-usb-mp-v1-4-60a904392438@quicinc.com (mailing list archive)
State Accepted
Commit a5652d05f81b6d0387c3894c63fae4db69ef9aad
Headers show
Series arm64: dts: qcom: sc8180x: Enable the USB multiport controller | expand

Commit Message

Bjorn Andersson May 25, 2024, 6:03 p.m. UTC 
From: Bjorn Andersson <quic_bjorande@quicinc.com>

The USB multiport controller needs a few additional resets, add these to
the driver.

Signed-off-by: Bjorn Andersson <quic_bjorande@quicinc.com>
---
 drivers/clk/qcom/gcc-sc8180x.c | 4 ++++
 1 file changed, 4 insertions(+)

Comments

Konrad Dybcio May 28, 2024, 12:39 p.m. UTC | #1 
On 5/25/24 20:03, Bjorn Andersson wrote:
> From: Bjorn Andersson <quic_bjorande@quicinc.com>
> 
> The USB multiport controller needs a few additional resets, add these to
> the driver.
> 
> Signed-off-by: Bjorn Andersson <quic_bjorande@quicinc.com>
> ---

The numbers look good

Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>

Konrad
diff mbox series

Patch

diff --git a/drivers/clk/qcom/gcc-sc8180x.c b/drivers/clk/qcom/gcc-sc8180x.c
index 5261bfc92b3d..f77578e98ca7 100644
--- a/drivers/clk/qcom/gcc-sc8180x.c
+++ b/drivers/clk/qcom/gcc-sc8180x.c
@@ -4546,6 +4546,10 @@  static const struct qcom_reset_map gcc_sc8180x_resets[] = {
 	[GCC_USB3_PHY_SEC_BCR] = { 0x50018 },
 	[GCC_USB3PHY_PHY_SEC_BCR] = { 0x5001c },
 	[GCC_USB3_DP_PHY_SEC_BCR] = { 0x50020 },
+	[GCC_USB3_UNIPHY_MP0_BCR] = { 0x50024 },
+	[GCC_USB3_UNIPHY_MP1_BCR] = { 0x50028 },
+	[GCC_USB3UNIPHY_PHY_MP0_BCR] = { 0x5002c },
+	[GCC_USB3UNIPHY_PHY_MP1_BCR] = { 0x50030 },
 	[GCC_SDCC2_BCR] = { 0x14000 },
 	[GCC_SDCC4_BCR] = { 0x16000 },
 	[GCC_TSIF_BCR] = { 0x36000 },