@@ -42,6 +42,7 @@
#define XHCI_EXT_CAPS_DEBUG 10
/* Vendor caps */
#define XHCI_EXT_CAPS_VENDOR_INTEL 192
+#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW 206
/* USB Legacy Support Capability - section 7.1.1 */
#define XHCI_HC_BIOS_OWNED (1 << 16)
#define XHCI_HC_OS_OWNED (1 << 24)
@@ -64,6 +65,10 @@
#define XHCI_HLC (1 << 19)
#define XHCI_BLC (1 << 20)
+/* Intel SPR shadow capability */
+#define XHCI_INTEL_SPR_ESS_PORT_OFFSET 0x8ac4 /* SuperSpeed port control */
+#define XHCI_INTEL_SPR_TUNEN BIT(4) /* Tunnel mode enabled */
+
/* command register values to disable interrupts and halt the HC */
/* start/stop HC execution - do not write unless HC is halted*/
#define XHCI_CMD_RUN (1 << 0)
@@ -752,6 +752,37 @@ static int xhci_exit_test_mode(struct xhci_hcd *xhci)
return xhci_reset(xhci, XHCI_RESET_SHORT_USEC);
}
+/**
+ * xhci_port_is_tunneled() - Check if USB3 connection is tunneled over USB4
+ * @xhci: xhci host controller
+ * @port: USB3 port to be checked.
+ *
+ * Some hosts can detect if a USB3 connection is native USB3 or tunneled over
+ * USB4. Intel hosts expose this via vendor specific extended capability 206
+ * eSS PORT registers TUNEN (tunnel enabled) bit.
+ *
+ * A USB3 device must be connected to the port to detect the tunnel.
+ *
+ * Return: true if USB3 connection is tunneled over USB4
+ */
+bool xhci_port_is_tunneled(struct xhci_hcd *xhci, struct xhci_port *port)
+{
+ void __iomem *base;
+ u32 offset;
+
+ base = &xhci->cap_regs->hc_capbase;
+ offset = xhci_find_next_ext_cap(base, 0, XHCI_EXT_CAPS_INTEL_SPR_SHADOW);
+
+ if (offset && offset <= XHCI_INTEL_SPR_ESS_PORT_OFFSET) {
+ offset = XHCI_INTEL_SPR_ESS_PORT_OFFSET + port->hcd_portnum * 0x20;
+
+ if (readl(base + offset) & XHCI_INTEL_SPR_TUNEN)
+ return true;
+ }
+
+ return false;
+}
+
void xhci_set_link_state(struct xhci_hcd *xhci, struct xhci_port *port,
u32 link_state)
{
@@ -4525,6 +4525,17 @@ static int xhci_update_device(struct usb_hcd *hcd, struct usb_device *udev)
struct xhci_port *port;
u32 capability;
+ /* Check if USB3 device at root port is tunneled over USB4 */
+ if (hcd->speed >= HCD_USB3 && !udev->parent->parent) {
+ port = xhci->usb3_rhub.ports[udev->portnum - 1];
+
+ if (xhci_port_is_tunneled(xhci, port))
+ dev_dbg(&udev->dev, "tunneled over USB4 link\n");
+ else
+ dev_dbg(&udev->dev, "native USB 3.x link\n");
+ return 0;
+ }
+
if (hcd->speed >= HCD_USB3 || !udev->lpm_capable || !xhci->hw_lpm_support)
return 0;
@@ -1929,6 +1929,7 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, u16 wIndex,
int xhci_hub_status_data(struct usb_hcd *hcd, char *buf);
int xhci_find_raw_port_number(struct usb_hcd *hcd, int port1);
struct xhci_hub *xhci_get_rhub(struct usb_hcd *hcd);
+bool xhci_port_is_tunneled(struct xhci_hcd *xhci, struct xhci_port *port);
void xhci_hc_died(struct xhci_hcd *xhci);
Knowledge about tunneled devices is useful in order to correctly describe the relationship between tunneled USB3 device and USB4 Host Interface, ensuring proper suspend and resume order, and to be able to power down Thunderbolt if there is no need for tunneling. Intel hosts share if a USB3 connection is native or tunneled via vendor specific "SPR eSS PORT" registers. These vendor registers are available if host supports a vendor specific SPR shadow extended capability with ID 206. Registers are per USB3 port and 0x20 apart. Knowing the tunneling status of the device connected to roothub is enough as all its children will have the same status. Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com> --- v2: minor return statement change, open up "return !!x" drivers/usb/host/xhci-ext-caps.h | 5 +++++ drivers/usb/host/xhci-hub.c | 31 +++++++++++++++++++++++++++++++ drivers/usb/host/xhci.c | 11 +++++++++++ drivers/usb/host/xhci.h | 1 + 4 files changed, 48 insertions(+)