@@ -148,11 +148,21 @@ static const struct property_entry dwc3_pci_intel_byt_properties[] = {
{}
};
+/*
+ * Intel Merrifield SoC uses these endpoints for tracing and they cannot
+ * be re-allocated if being used because the side band flow control signals
+ * are hard wired to certain endpoints:
+ * - 1 High BW Bulk IN (IN#1) (RTIT)
+ * - 1 1KB BW Bulk IN (IN#8) + 1 1KB BW Bulk OUT (Run Control) (OUT#8)
+ */
+static const u8 dwc3_pci_mrfld_reserved_endpoints[] = { 3, 16, 17 };
+
static const struct property_entry dwc3_pci_mrfld_properties[] = {
PROPERTY_ENTRY_STRING("dr_mode", "otg"),
PROPERTY_ENTRY_STRING("linux,extcon-name", "mrfld_bcove_pwrsrc"),
PROPERTY_ENTRY_BOOL("snps,dis_u3_susphy_quirk"),
PROPERTY_ENTRY_BOOL("snps,dis_u2_susphy_quirk"),
+ PROPERTY_ENTRY_U8_ARRAY("snps,reserved-endpoints", dwc3_pci_mrfld_reserved_endpoints),
PROPERTY_ENTRY_BOOL("snps,usb2-gadget-lpm-disable"),
PROPERTY_ENTRY_BOOL("linux,sysdev_is_parent"),
{}
Intel Merrifield SoC uses these endpoints for tracing and they cannot be re-allocated if being used because the side band flow control signals are hard wired to certain endpoints: • 1 High BW Bulk IN (IN#1) (RTIT) • 1 1KB BW Bulk IN (IN#8) + 1 1KB BW Bulk OUT (Run Control) (OUT#8) In device mode, since RTIT (EP#1) and EXI/RunControl (EP#8) uses External Buffer Control (EBC) mode, these endpoints are to be mapped to EBC mode (to be done by EXI target driver). Additionally TRB for RTIT and EXI are maintained in STM (System Trace Module) unit and the EXI target driver will as well configure the TRB location for EP #1 IN and EP#8 (IN and OUT). Since STM/PTI and EXI hardware blocks manage these endpoints and interface to OTG3 controller through EBC interface, there is no need to enable any events (such as XferComplete etc) for these end points. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/usb/dwc3/dwc3-pci.c | 10 ++++++++++ 1 file changed, 10 insertions(+)