@@ -648,7 +648,8 @@ static int wl12xx_identify_chip(struct wl1271 *wl)
wl->quirks |= WLCORE_QUIRK_LEGACY_NVS |
WLCORE_QUIRK_DUAL_PROBE_TMPL |
WLCORE_QUIRK_TKIP_HEADER_SPACE |
- WLCORE_QUIRK_START_STA_FAILS;
+ WLCORE_QUIRK_START_STA_FAILS |
+ WLCORE_QUIRK_AP_ZERO_SESSION_ID;
wl->sr_fw_name = WL127X_FW_NAME_SINGLE;
wl->mr_fw_name = WL127X_FW_NAME_MULTI;
memcpy(&wl->conf.mem, &wl12xx_default_priv_conf.mem_wl127x,
@@ -671,7 +672,8 @@ static int wl12xx_identify_chip(struct wl1271 *wl)
wl->quirks |= WLCORE_QUIRK_LEGACY_NVS |
WLCORE_QUIRK_DUAL_PROBE_TMPL |
WLCORE_QUIRK_TKIP_HEADER_SPACE |
- WLCORE_QUIRK_START_STA_FAILS;
+ WLCORE_QUIRK_START_STA_FAILS |
+ WLCORE_QUIRK_AP_ZERO_SESSION_ID;
wl->plt_fw_name = WL127X_PLT_FW_NAME;
wl->sr_fw_name = WL127X_FW_NAME_SINGLE;
wl->mr_fw_name = WL127X_FW_NAME_MULTI;
@@ -699,7 +701,8 @@ static int wl12xx_identify_chip(struct wl1271 *wl)
wl->quirks |= WLCORE_QUIRK_TX_BLOCKSIZE_ALIGN |
WLCORE_QUIRK_DUAL_PROBE_TMPL |
WLCORE_QUIRK_TKIP_HEADER_SPACE |
- WLCORE_QUIRK_START_STA_FAILS;
+ WLCORE_QUIRK_START_STA_FAILS |
+ WLCORE_QUIRK_AP_ZERO_SESSION_ID;
wlcore_set_min_fw_ver(wl, WL128X_CHIP_VER,
WL128X_IFTYPE_SR_VER, WL128X_MAJOR_SR_VER,
@@ -288,9 +288,14 @@ static void wl1271_tx_fill_hdr(struct wl1271 *wl, struct wl12xx_vif *wlvif,
tx_attr |= TX_HW_ATTR_TX_DUMMY_REQ;
} else if (wlvif) {
+ u8 session_id = wl->session_ids[hlid];
+
+ if ((wl->quirks & WLCORE_QUIRK_AP_ZERO_SESSION_ID) &&
+ (wlvif->bss_type == BSS_TYPE_AP_BSS))
+ session_id = 0;
+
/* configure the tx attributes */
- tx_attr = wl->session_ids[hlid] <<
- TX_HW_ATTR_OFST_SESSION_COUNTER;
+ tx_attr = session_id << TX_HW_ATTR_OFST_SESSION_COUNTER;
}
desc->hlid = hlid;
@@ -555,6 +555,8 @@ wlcore_set_min_fw_ver(struct wl1271 *wl, unsigned int chip,
/* Firmware requires reg domain configuration for active calibration */
#define WLCORE_QUIRK_REGDOMAIN_CONF BIT(11)
+/* The FW only support a zero session id for AP */
+#define WLCORE_QUIRK_AP_ZERO_SESSION_ID BIT(12)
/* TODO: move all these common registers and values elsewhere */
#define HW_ACCESS_ELP_CTRL_REG 0x1FFFC
The 12xx FW doesn't support non-zero session ids for AP-mode. Introduce an appropriate quirk to make sure the session id is always zero when needed. Signed-off-by: Arik Nemtsov <arik@wizery.com> --- This fixes AP mode for 12xx. I've tested a branch based on Luca's git with part1+2+3 applied in addition to this patch. Both AP and STA work well on 12xx and 18xx. drivers/net/wireless/ti/wl12xx/main.c | 9 ++++++--- drivers/net/wireless/ti/wlcore/tx.c | 9 +++++++-- drivers/net/wireless/ti/wlcore/wlcore.h | 2 ++ 3 files changed, 15 insertions(+), 5 deletions(-)