[v2,net,0/2] use bulk reads for ocelot statistics

Message

Colin Foster Jan. 25, 2022, 6:35 a.m. UTC

Ocelot loops over memory regions to gather stats on different ports.
These regions are mostly continuous, and are ordered. This patch set
uses that information to break the stats reads into regions that can get
read in bulk.

The motiviation is for general cleanup, but also for SPI. Performing two
back-to-back reads on a SPI bus require toggling the CS line, holding,
re-toggling the CS line, sending 3 address bytes, sending N padding
bytes, then actually performing the read. Bulk reads could reduce almost
all of that overhead, but require that the reads are performed via
regmap_bulk_read.

v1 > v2: reword commit messages

Colin Foster (2):
  net: mscc: ocelot: add ability to perform bulk reads
  net: mscc: ocelot: use bulk reads for stats

 drivers/net/ethernet/mscc/ocelot.c    | 76 ++++++++++++++++++++++-----
 drivers/net/ethernet/mscc/ocelot_io.c | 13 +++++
 include/soc/mscc/ocelot.h             | 12 +++++
 3 files changed, 88 insertions(+), 13 deletions(-)