| Message ID | 20240603092757.71902-1-christophe.roullier@foss.st.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | Series to deliver Ethernet for STM32MP13 | expand |
On Mon, 03 Jun 2024 11:27:46 +0200, Christophe Roullier wrote: > STM32MP13 is STM32 SOC with 2 GMACs instances > GMAC IP version is SNPS 4.20. > GMAC IP configure with 1 RX and 1 TX queue. > DMA HW capability register supported > RX Checksum Offload Engine supported > TX Checksum insertion supported > Wake-Up On Lan supported > TSO supported > Rework dwmac glue to simplify management for next stm32 (integrate RFC from Marek) > > V2: - Remark from Rob Herring (add Krzysztof's ack in patch 02/11, update in yaml) > Remark from Serge Semin (upate commits msg) > V3: - Remove PHY regulator patch and Ethernet2 DT because need to clarify how to > manage PHY regulator (in glue or PHY side) > - Integrate RFC from Marek > - Remark from Rob Herring in YAML documentation > > Christophe Roullier (6): > dt-bindings: net: add STM32MP13 compatible in documentation for stm32 > net: ethernet: stmmac: add management of stm32mp13 for stm32 > ARM: dts: stm32: add ethernet1 and ethernet2 support on stm32mp13 > ARM: dts: stm32: add ethernet1/2 RMII pins for STM32MP13F-DK board > ARM: dts: stm32: add ethernet1 for STM32MP135F-DK board > ARM: multi_v7_defconfig: Add MCP23S08 pinctrl support > > Marek Vasut (5): > net: stmmac: dwmac-stm32: Separate out external clock rate validation > net: stmmac: dwmac-stm32: Separate out external clock selector > net: stmmac: dwmac-stm32: Extract PMCR configuration > net: stmmac: dwmac-stm32: Clean up the debug prints > net: stmmac: dwmac-stm32: Fix Mhz to MHz > > .../devicetree/bindings/net/stm32-dwmac.yaml | 41 +++- > arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi | 71 +++++++ > arch/arm/boot/dts/st/stm32mp131.dtsi | 31 +++ > arch/arm/boot/dts/st/stm32mp133.dtsi | 30 +++ > arch/arm/boot/dts/st/stm32mp135f-dk.dts | 24 +++ > arch/arm/configs/multi_v7_defconfig | 1 + > .../net/ethernet/stmicro/stmmac/dwmac-stm32.c | 176 ++++++++++++++---- > 7 files changed, 327 insertions(+), 47 deletions(-) > > -- > 2.25.1 > > > My bot found new DTB warnings on the .dts files added or changed in this series. Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings are fixed by another series. Ultimately, it is up to the platform maintainer whether these warnings are acceptable or not. No need to reply unless the platform maintainer has comments. If you already ran DT checks and didn't see these error(s), then make sure dt-schema is up to date: pip3 install dtschema --upgrade New warnings running 'make CHECK_DTBS=y st/stm32mp135f-dk.dtb' for 20240603092757.71902-1-christophe.roullier@foss.st.com: arch/arm/boot/dts/st/stm32mp135f-dk.dtb: adc@48003000: 'ethernet@5800e000' does not match any of the regexes: '^adc@[0-9]+$', 'pinctrl-[0-9]+' from schema $id: http://devicetree.org/schemas/iio/adc/st,stm32-adc.yaml#
STM32MP13 is STM32 SOC with 2 GMACs instances GMAC IP version is SNPS 4.20. GMAC IP configure with 1 RX and 1 TX queue. DMA HW capability register supported RX Checksum Offload Engine supported TX Checksum insertion supported Wake-Up On Lan supported TSO supported Rework dwmac glue to simplify management for next stm32 (integrate RFC from Marek) V2: - Remark from Rob Herring (add Krzysztof's ack in patch 02/11, update in yaml) Remark from Serge Semin (upate commits msg) V3: - Remove PHY regulator patch and Ethernet2 DT because need to clarify how to manage PHY regulator (in glue or PHY side) - Integrate RFC from Marek - Remark from Rob Herring in YAML documentation Christophe Roullier (6): dt-bindings: net: add STM32MP13 compatible in documentation for stm32 net: ethernet: stmmac: add management of stm32mp13 for stm32 ARM: dts: stm32: add ethernet1 and ethernet2 support on stm32mp13 ARM: dts: stm32: add ethernet1/2 RMII pins for STM32MP13F-DK board ARM: dts: stm32: add ethernet1 for STM32MP135F-DK board ARM: multi_v7_defconfig: Add MCP23S08 pinctrl support Marek Vasut (5): net: stmmac: dwmac-stm32: Separate out external clock rate validation net: stmmac: dwmac-stm32: Separate out external clock selector net: stmmac: dwmac-stm32: Extract PMCR configuration net: stmmac: dwmac-stm32: Clean up the debug prints net: stmmac: dwmac-stm32: Fix Mhz to MHz .../devicetree/bindings/net/stm32-dwmac.yaml | 41 +++- arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi | 71 +++++++ arch/arm/boot/dts/st/stm32mp131.dtsi | 31 +++ arch/arm/boot/dts/st/stm32mp133.dtsi | 30 +++ arch/arm/boot/dts/st/stm32mp135f-dk.dts | 24 +++ arch/arm/configs/multi_v7_defconfig | 1 + .../net/ethernet/stmicro/stmmac/dwmac-stm32.c | 176 ++++++++++++++---- 7 files changed, 327 insertions(+), 47 deletions(-)