deleted file mode 100644
@@ -1,252 +0,0 @@
-/* SPDX-License-Identifier: GPL-2.0-only */
-/****************************************************************************
- * Driver for Solarflare network controllers and boards
- * Copyright 2010-2012 Solarflare Communications Inc.
- */
-#ifndef _VFDI_H
-#define _VFDI_H
-
-/**
- * DOC: Virtual Function Driver Interface
- *
- * This file contains software structures used to form a two way
- * communication channel between the VF driver and the PF driver,
- * named Virtual Function Driver Interface (VFDI).
- *
- * For the purposes of VFDI, a page is a memory region with size and
- * alignment of 4K. All addresses are DMA addresses to be used within
- * the domain of the relevant VF.
- *
- * The only hardware-defined channels for a VF driver to communicate
- * with the PF driver are the event mailboxes (%FR_CZ_USR_EV
- * registers). Writing to these registers generates an event with
- * EV_CODE = EV_CODE_USR_EV, USER_QID set to the index of the mailbox
- * and USER_EV_REG_VALUE set to the value written. The PF driver may
- * direct or disable delivery of these events by setting
- * %FR_CZ_USR_EV_CFG.
- *
- * The PF driver can send arbitrary events to arbitrary event queues.
- * However, for consistency, VFDI events from the PF are defined to
- * follow the same form and be sent to the first event queue assigned
- * to the VF while that queue is enabled by the VF driver.
- *
- * The general form of the variable bits of VFDI events is:
- *
- * 0 16 24 31
- * | DATA | TYPE | SEQ |
- *
- * SEQ is a sequence number which should be incremented by 1 (modulo
- * 256) for each event. The sequence numbers used in each direction
- * are independent.
- *
- * The VF submits requests of type &struct vfdi_req by sending the
- * address of the request (ADDR) in a series of 4 events:
- *
- * 0 16 24 31
- * | ADDR[0:15] | VFDI_EV_TYPE_REQ_WORD0 | SEQ |
- * | ADDR[16:31] | VFDI_EV_TYPE_REQ_WORD1 | SEQ+1 |
- * | ADDR[32:47] | VFDI_EV_TYPE_REQ_WORD2 | SEQ+2 |
- * | ADDR[48:63] | VFDI_EV_TYPE_REQ_WORD3 | SEQ+3 |
- *
- * The address must be page-aligned. After receiving such a valid
- * series of events, the PF driver will attempt to read the request
- * and write a response to the same address. In case of an invalid
- * sequence of events or a DMA error, there will be no response.
- *
- * The VF driver may request that the PF driver writes status
- * information into its domain asynchronously. After writing the
- * status, the PF driver will send an event of the form:
- *
- * 0 16 24 31
- * | reserved | VFDI_EV_TYPE_STATUS | SEQ |
- *
- * In case the VF must be reset for any reason, the PF driver will
- * send an event of the form:
- *
- * 0 16 24 31
- * | reserved | VFDI_EV_TYPE_RESET | SEQ |
- *
- * It is then the responsibility of the VF driver to request
- * reinitialisation of its queues.
- */
-#define VFDI_EV_SEQ_LBN 24
-#define VFDI_EV_SEQ_WIDTH 8
-#define VFDI_EV_TYPE_LBN 16
-#define VFDI_EV_TYPE_WIDTH 8
-#define VFDI_EV_TYPE_REQ_WORD0 0
-#define VFDI_EV_TYPE_REQ_WORD1 1
-#define VFDI_EV_TYPE_REQ_WORD2 2
-#define VFDI_EV_TYPE_REQ_WORD3 3
-#define VFDI_EV_TYPE_STATUS 4
-#define VFDI_EV_TYPE_RESET 5
-#define VFDI_EV_DATA_LBN 0
-#define VFDI_EV_DATA_WIDTH 16
-
-struct vfdi_endpoint {
- u8 mac_addr[ETH_ALEN];
- __be16 tci;
-};
-
-/**
- * enum vfdi_op - VFDI operation enumeration
- * @VFDI_OP_RESPONSE: Indicates a response to the request.
- * @VFDI_OP_INIT_EVQ: Initialize SRAM entries and initialize an EVQ.
- * @VFDI_OP_INIT_RXQ: Initialize SRAM entries and initialize an RXQ.
- * @VFDI_OP_INIT_TXQ: Initialize SRAM entries and initialize a TXQ.
- * @VFDI_OP_FINI_ALL_QUEUES: Flush all queues, finalize all queues, then
- * finalize the SRAM entries.
- * @VFDI_OP_INSERT_FILTER: Insert a MAC filter targeting the given RXQ.
- * @VFDI_OP_REMOVE_ALL_FILTERS: Remove all filters.
- * @VFDI_OP_SET_STATUS_PAGE: Set the DMA page(s) used for status updates
- * from PF and write the initial status.
- * @VFDI_OP_CLEAR_STATUS_PAGE: Clear the DMA page(s) used for status
- * updates from PF.
- */
-enum vfdi_op {
- VFDI_OP_RESPONSE = 0,
- VFDI_OP_INIT_EVQ = 1,
- VFDI_OP_INIT_RXQ = 2,
- VFDI_OP_INIT_TXQ = 3,
- VFDI_OP_FINI_ALL_QUEUES = 4,
- VFDI_OP_INSERT_FILTER = 5,
- VFDI_OP_REMOVE_ALL_FILTERS = 6,
- VFDI_OP_SET_STATUS_PAGE = 7,
- VFDI_OP_CLEAR_STATUS_PAGE = 8,
- VFDI_OP_LIMIT,
-};
-
-/* Response codes for VFDI operations. Other values may be used in future. */
-#define VFDI_RC_SUCCESS 0
-#define VFDI_RC_ENOMEM (-12)
-#define VFDI_RC_EINVAL (-22)
-#define VFDI_RC_EOPNOTSUPP (-95)
-#define VFDI_RC_ETIMEDOUT (-110)
-
-/**
- * struct vfdi_req - Request from VF driver to PF driver
- * @op: Operation code or response indicator, taken from &enum vfdi_op.
- * @rc: Response code. Set to 0 on success or a negative error code on failure.
- * @u.init_evq.index: Index of event queue to create.
- * @u.init_evq.buf_count: Number of 4k buffers backing event queue.
- * @u.init_evq.addr: Array of length %u.init_evq.buf_count containing DMA
- * address of each page backing the event queue.
- * @u.init_rxq.index: Index of receive queue to create.
- * @u.init_rxq.buf_count: Number of 4k buffers backing receive queue.
- * @u.init_rxq.evq: Instance of event queue to target receive events at.
- * @u.init_rxq.label: Label used in receive events.
- * @u.init_rxq.flags: Unused.
- * @u.init_rxq.addr: Array of length %u.init_rxq.buf_count containing DMA
- * address of each page backing the receive queue.
- * @u.init_txq.index: Index of transmit queue to create.
- * @u.init_txq.buf_count: Number of 4k buffers backing transmit queue.
- * @u.init_txq.evq: Instance of event queue to target transmit completion
- * events at.
- * @u.init_txq.label: Label used in transmit completion events.
- * @u.init_txq.flags: Checksum offload flags.
- * @u.init_txq.addr: Array of length %u.init_txq.buf_count containing DMA
- * address of each page backing the transmit queue.
- * @u.mac_filter.rxq: Insert MAC filter at VF local address/VLAN targeting
- * all traffic at this receive queue.
- * @u.mac_filter.flags: MAC filter flags.
- * @u.set_status_page.dma_addr: Base address for the &struct vfdi_status.
- * This address must be page-aligned and the PF may write up to a
- * whole page (allowing for extension of the structure).
- * @u.set_status_page.peer_page_count: Number of additional pages the VF
- * has provided into which peer addresses may be DMAd.
- * @u.set_status_page.peer_page_addr: Array of DMA addresses of pages.
- * If the number of peers exceeds 256, then the VF must provide
- * additional pages in this array. The PF will then DMA up to
- * 512 vfdi_endpoint structures into each page. These addresses
- * must be page-aligned.
- */
-struct vfdi_req {
- u32 op;
- u32 reserved1;
- s32 rc;
- u32 reserved2;
- union {
- struct {
- u32 index;
- u32 buf_count;
- u64 addr[];
- } init_evq;
- struct {
- u32 index;
- u32 buf_count;
- u32 evq;
- u32 label;
- u32 flags;
-#define VFDI_RXQ_FLAG_SCATTER_EN 1
- u32 reserved;
- u64 addr[];
- } init_rxq;
- struct {
- u32 index;
- u32 buf_count;
- u32 evq;
- u32 label;
- u32 flags;
-#define VFDI_TXQ_FLAG_IP_CSUM_DIS 1
-#define VFDI_TXQ_FLAG_TCPUDP_CSUM_DIS 2
- u32 reserved;
- u64 addr[];
- } init_txq;
- struct {
- u32 rxq;
- u32 flags;
-#define VFDI_MAC_FILTER_FLAG_RSS 1
-#define VFDI_MAC_FILTER_FLAG_SCATTER 2
- } mac_filter;
- struct {
- u64 dma_addr;
- u64 peer_page_count;
- u64 peer_page_addr[];
- } set_status_page;
- } u;
-};
-
-/**
- * struct vfdi_status - Status provided by PF driver to VF driver
- * @generation_start: A generation count DMA'd to VF *before* the
- * rest of the structure.
- * @generation_end: A generation count DMA'd to VF *after* the
- * rest of the structure.
- * @version: Version of this structure; currently set to 1. Later
- * versions must either be layout-compatible or only be sent to VFs
- * that specifically request them.
- * @length: Total length of this structure including embedded tables
- * @vi_scale: log2 the number of VIs available on this VF. This quantity
- * is used by the hardware for register decoding.
- * @max_tx_channels: The maximum number of transmit queues the VF can use.
- * @rss_rxq_count: The number of receive queues present in the shared RSS
- * indirection table.
- * @peer_count: Total number of peers in the complete peer list. If larger
- * than ARRAY_SIZE(%peers), then the VF must provide sufficient
- * additional pages each of which is filled with vfdi_endpoint structures.
- * @local: The MAC address and outer VLAN tag of *this* VF
- * @peers: Table of peer addresses. The @tci fields in these structures
- * are currently unused and must be ignored. Additional peers are
- * written into any additional pages provided by the VF.
- * @timer_quantum_ns: Timer quantum (nominal period between timer ticks)
- * for interrupt moderation timers, in nanoseconds. This member is only
- * present if @length is sufficiently large.
- */
-struct vfdi_status {
- u32 generation_start;
- u32 generation_end;
- u32 version;
- u32 length;
- u8 vi_scale;
- u8 max_tx_channels;
- u8 rss_rxq_count;
- u8 reserved1;
- u16 peer_count;
- u16 reserved2;
- struct vfdi_endpoint local;
- struct vfdi_endpoint peers[256];
-
- /* Members below here extend version 1 of this structure */
- u32 timer_quantum_ns;
-};
-
-#endif