diff mbox series

[net-next,v3,3/3] net: phy: mscc: coma mode disabled for VSC8514

Message ID 20210216152944.27266-4-bjarni.jonasson@microchip.com (mailing list archive)
State Accepted
Commit ca0d7fd0a58dfc9503775dae7daee341c115e0c7
Delegated to: Netdev Maintainers
Headers show
Series Fixes applied to VCS8514 | expand

Checks

Context Check Description
netdev/cover_letter success Link
netdev/fixes_present success Link
netdev/patch_count success Link
netdev/tree_selection success Clearly marked for net-next
netdev/subject_prefix success Link
netdev/cc_maintainers fail 2 blamed authors not CCed: quentin.schulz@bootlin.com kavyasree.kotagiri@microchip.com; 3 maintainers not CCed: quentin.schulz@bootlin.com kavyasree.kotagiri@microchip.com michael@walle.cc
netdev/source_inline success Was 0 now: 0
netdev/verify_signedoff success Link
netdev/module_param success Was 0 now: 0
netdev/build_32bit success Errors and warnings before: 0 this patch: 0
netdev/kdoc success Errors and warnings before: 0 this patch: 0
netdev/verify_fixes success Link
netdev/checkpatch success total: 0 errors, 0 warnings, 0 checks, 38 lines checked
netdev/build_allmodconfig_warn success Errors and warnings before: 0 this patch: 0
netdev/header_inline success Link
netdev/stable success Stable not CCed

Commit Message

Bjarni Jonasson Feb. 16, 2021, 3:29 p.m. UTC
The 'coma mode' (configurable through sw or hw) provides an
optional feature that may be used to control when the PHYs become active.
The typical usage is to synchronize the link-up time across
all PHY instances. This patch releases coma mode if not done by hardware,
otherwise the phys will not link-up.

Fixes: e4f9ba642f0b ("net: phy: mscc: add support for VSC8514 PHY.")
Signed-off-by: Steen Hegelund <steen.hegelund@microchip.com>
Signed-off-by: Bjarni Jonasson <bjarni.jonasson@microchip.com>
---
 drivers/net/phy/mscc/mscc.h      |  4 ++++
 drivers/net/phy/mscc/mscc_main.c | 16 ++++++++++++++++
 2 files changed, 20 insertions(+)
diff mbox series

Patch

diff --git a/drivers/net/phy/mscc/mscc.h b/drivers/net/phy/mscc/mscc.h
index 2028c319f14d..a50235fdf7d9 100644
--- a/drivers/net/phy/mscc/mscc.h
+++ b/drivers/net/phy/mscc/mscc.h
@@ -140,6 +140,10 @@  enum rgmii_clock_delay {
 #define MSCC_PHY_PAGE_1588		  0x1588 /* PTP (1588) */
 #define MSCC_PHY_PAGE_TEST		  0x2a30 /* Test reg */
 #define MSCC_PHY_PAGE_TR		  0x52b5 /* Token ring registers */
+#define MSCC_PHY_GPIO_CONTROL_2           14
+
+#define MSCC_PHY_COMA_MODE		  0x2000 /* input(1) / output(0) */
+#define MSCC_PHY_COMA_OUTPUT		  0x1000 /* value to output */
 
 /* Extended Page 1 Registers */
 #define MSCC_PHY_CU_MEDIA_CRC_VALID_CNT	  18
diff --git a/drivers/net/phy/mscc/mscc_main.c b/drivers/net/phy/mscc/mscc_main.c
index 0e6e7076a740..3a7705228ed5 100644
--- a/drivers/net/phy/mscc/mscc_main.c
+++ b/drivers/net/phy/mscc/mscc_main.c
@@ -1516,6 +1516,21 @@  static void vsc8584_get_base_addr(struct phy_device *phydev)
 	vsc8531->addr = addr;
 }
 
+static void vsc85xx_coma_mode_release(struct phy_device *phydev)
+{
+	/* The coma mode (pin or reg) provides an optional feature that
+	 * may be used to control when the PHYs become active.
+	 * Alternatively the COMA_MODE pin may be connected low
+	 * so that the PHYs are fully active once out of reset.
+	 */
+
+	/* Enable output (mode=0) and write zero to it */
+	vsc85xx_phy_write_page(phydev, MSCC_PHY_PAGE_EXTENDED_GPIO);
+	__phy_modify(phydev, MSCC_PHY_GPIO_CONTROL_2,
+		     MSCC_PHY_COMA_MODE | MSCC_PHY_COMA_OUTPUT, 0);
+	vsc85xx_phy_write_page(phydev, MSCC_PHY_PAGE_STANDARD);
+}
+
 static int vsc8584_config_init(struct phy_device *phydev)
 {
 	struct vsc8531_private *vsc8531 = phydev->priv;
@@ -1962,6 +1977,7 @@  static int vsc8514_config_init(struct phy_device *phydev)
 		ret = vsc8514_config_host_serdes(phydev);
 		if (ret)
 			goto err;
+		vsc85xx_coma_mode_release(phydev);
 	}
 
 	phy_unlock_mdio_bus(phydev);