@@ -1591,12 +1591,40 @@ static const struct dsa_switch_ops qca8k_switch_ops = {
.phylink_mac_link_up = qca8k_phylink_mac_link_up,
};
+static int qca8k_read_switch_id(struct qca8k_priv *priv)
+{
+ const struct qca8k_match_data *data;
+ u32 val;
+ u8 id;
+
+ /* get the switches ID from the compatible */
+ data = of_device_get_match_data(priv->dev);
+ if (!data)
+ return -ENODEV;
+
+ val = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
+ if (val < 0)
+ return -ENODEV;
+
+ id = QCA8K_MASK_CTRL_DEVICE_ID(val & QCA8K_MASK_CTRL_DEVICE_ID_MASK);
+ if (id != data->id) {
+ dev_err(priv->dev, "Switch id detected %x but expected %x", id, data->id);
+ return -ENODEV;
+ }
+
+ priv->switch_id = id;
+
+ /* Save revision to communicate to the internal PHY driver */
+ priv->switch_revision = (val & QCA8K_MASK_CTRL_REV_ID_MASK);
+
+ return 0;
+}
+
static int
qca8k_sw_probe(struct mdio_device *mdiodev)
{
- const struct qca8k_match_data *data;
struct qca8k_priv *priv;
- u32 id;
+ int ret;
/* allocate the private data struct so that we can probe the switches
* ID register
@@ -1622,24 +1650,11 @@ qca8k_sw_probe(struct mdio_device *mdiodev)
gpiod_set_value_cansleep(priv->reset_gpio, 0);
}
- /* get the switches ID from the compatible */
- data = of_device_get_match_data(&mdiodev->dev);
- if (!data)
- return -ENODEV;
-
- /* read the switches ID register */
- id = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
- if (id < 0)
- return id;
-
- id >>= QCA8K_MASK_CTRL_ID_S;
- id &= QCA8K_MASK_CTRL_ID_M;
- if (id != data->id) {
- dev_err(&mdiodev->dev, "Switch id detected %x but expected %x", id, data->id);
- return -ENODEV;
- }
+ /* Check the detected switch id */
+ ret = qca8k_read_switch_id(priv);
+ if (ret)
+ return ret;
- priv->switch_id = id;
priv->ds = devm_kzalloc(&mdiodev->dev, sizeof(*priv->ds), GFP_KERNEL);
if (!priv->ds)
return -ENOMEM;
@@ -30,8 +30,10 @@
/* Global control registers */
#define QCA8K_REG_MASK_CTRL 0x000
-#define QCA8K_MASK_CTRL_ID_M 0xff
-#define QCA8K_MASK_CTRL_ID_S 8
+#define QCA8K_MASK_CTRL_REV_ID_MASK GENMASK(7, 0)
+#define QCA8K_MASK_CTRL_REV_ID(x) ((x) >> 0)
+#define QCA8K_MASK_CTRL_DEVICE_ID_MASK GENMASK(15, 8)
+#define QCA8K_MASK_CTRL_DEVICE_ID(x) ((x) >> 8)
#define QCA8K_REG_PORT0_PAD_CTRL 0x004
#define QCA8K_REG_PORT5_PAD_CTRL 0x008
#define QCA8K_REG_PORT6_PAD_CTRL 0x00c
@@ -251,6 +253,7 @@ struct qca8k_match_data {
struct qca8k_priv {
u8 switch_id;
+ u8 switch_revision;
struct regmap *regmap;
struct mii_bus *bus;
struct ar8xxx_port_status port_sts[QCA8K_NUM_PORTS];
qca8k internal phy driver require some special debug value to be set based on the switch revision. Rework the switch id read function to also read the chip revision. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- drivers/net/dsa/qca8k.c | 53 ++++++++++++++++++++++++++--------------- drivers/net/dsa/qca8k.h | 7 ++++-- 2 files changed, 39 insertions(+), 21 deletions(-)