diff mbox series

[05/11] batman-adv: mcast: add MRD + routable IPv4 multicast with bridges support

Message ID 20210608152700.30315-6-sw@simonwunderlich.de (mailing list archive)
State Accepted
Commit 7a68cc16b82c963c096387917ced11a27c352261
Delegated to: Netdev Maintainers
Headers show
Series [01/11] batman-adv: Start new development cycle | expand

Checks

Context Check Description
netdev/cover_letter success Pull request
netdev/fixes_present success Link
netdev/patch_count success Link
netdev/tree_selection success Guessed tree name to be net-next
netdev/subject_prefix warning Target tree name not specified in the subject
netdev/cc_maintainers warning 2 maintainers not CCed: mareklindner@neomailbox.ch a@unstable.cc
netdev/source_inline success Was 1 now: 0
netdev/verify_signedoff success Link
netdev/module_param success Was 0 now: 0
netdev/build_32bit success Errors and warnings before: 0 this patch: 0
netdev/kdoc success Errors and warnings before: 0 this patch: 0
netdev/verify_fixes success Link
netdev/checkpatch success total: 0 errors, 0 warnings, 0 checks, 58 lines checked
netdev/build_allmodconfig_warn success Errors and warnings before: 0 this patch: 0
netdev/header_inline success Link

Commit Message

Simon Wunderlich June 8, 2021, 3:26 p.m. UTC
From: Linus Lüssing <linus.luessing@c0d3.blue>

This adds support for routable IPv4 multicast addresses
(224.0.0.0/4, excluding 224.0.0.0/24) in bridged setups.

This utilizes the Multicast Router Discovery (MRD, RFC4286) support
in the Linux bridge. batman-adv will now query the Linux bridge for
IPv4 multicast routers, which the bridge has previously learned about
via MRD.

This allows us to then safely send routable IPv4 multicast packets in
bridged setups to multicast listeners and multicast routers only. Before
we had to flood such packets to avoid potential multicast packet loss to
IPv4 multicast routers, which we were not able to detect before.

With the bridge MRD integration, we are now also able to perform more
fine-grained detection of IPv6 multicast routers in bridged setups:
Before we were "guessing" IPv6 multicast routers by looking up multicast
listeners for the link-local All Routers multicast address (ff02::2),
which every IPv6 multicast router is listening to. However this would
also include more nodes than necessary: For instance nodes which are
just a router for unicast, but not multicast would be included, too.

Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>
Signed-off-by: Sven Eckelmann <sven@narfation.org>
Signed-off-by: Simon Wunderlich <sw@simonwunderlich.de>
---
 net/batman-adv/multicast.c | 41 +++++---------------------------------
 1 file changed, 5 insertions(+), 36 deletions(-)
diff mbox series

Patch

diff --git a/net/batman-adv/multicast.c b/net/batman-adv/multicast.c
index 1d63c8cbbfe7..923e2197c2db 100644
--- a/net/batman-adv/multicast.c
+++ b/net/batman-adv/multicast.c
@@ -193,53 +193,22 @@  static u8 batadv_mcast_mla_rtr_flags_softif_get(struct batadv_priv *bat_priv,
  *	BATADV_MCAST_WANT_NO_RTR6: No IPv6 multicast router is present
  *	The former two OR'd: no multicast router is present
  */
-#if IS_ENABLED(CONFIG_IPV6)
 static u8 batadv_mcast_mla_rtr_flags_bridge_get(struct batadv_priv *bat_priv,
 						struct net_device *bridge)
 {
-	struct list_head bridge_mcast_list = LIST_HEAD_INIT(bridge_mcast_list);
 	struct net_device *dev = bat_priv->soft_iface;
-	struct br_ip_list *br_ip_entry, *tmp;
-	u8 flags = BATADV_MCAST_WANT_NO_RTR6;
-	int ret;
+	u8 flags = BATADV_NO_FLAGS;
 
 	if (!bridge)
 		return BATADV_MCAST_WANT_NO_RTR4 | BATADV_MCAST_WANT_NO_RTR6;
 
-	/* TODO: ask the bridge if a multicast router is present (the bridge
-	 * is capable of performing proper RFC4286 multicast router
-	 * discovery) instead of searching for a ff02::2 listener here
-	 */
-	ret = br_multicast_list_adjacent(dev, &bridge_mcast_list);
-	if (ret < 0)
-		return BATADV_NO_FLAGS;
-
-	list_for_each_entry_safe(br_ip_entry, tmp, &bridge_mcast_list, list) {
-		/* the bridge snooping does not maintain IPv4 link-local
-		 * addresses - therefore we won't find any IPv4 multicast router
-		 * address here, only IPv6 ones
-		 */
-		if (br_ip_entry->addr.proto == htons(ETH_P_IPV6) &&
-		    ipv6_addr_is_ll_all_routers(&br_ip_entry->addr.dst.ip6))
-			flags &= ~BATADV_MCAST_WANT_NO_RTR6;
-
-		list_del(&br_ip_entry->list);
-		kfree(br_ip_entry);
-	}
+	if (!br_multicast_has_router_adjacent(dev, ETH_P_IP))
+		flags |= BATADV_MCAST_WANT_NO_RTR4;
+	if (!br_multicast_has_router_adjacent(dev, ETH_P_IPV6))
+		flags |= BATADV_MCAST_WANT_NO_RTR6;
 
 	return flags;
 }
-#else
-static inline u8
-batadv_mcast_mla_rtr_flags_bridge_get(struct batadv_priv *bat_priv,
-				      struct net_device *bridge)
-{
-	if (bridge)
-		return BATADV_NO_FLAGS;
-	else
-		return BATADV_MCAST_WANT_NO_RTR4 | BATADV_MCAST_WANT_NO_RTR6;
-}
-#endif
 
 /**
  * batadv_mcast_mla_rtr_flags_get() - get multicast router flags