diff mbox series

[net-next,13/18] ptp: ocp: Add NMEA output

Message ID 20210915021636.153754-14-jonathan.lemon@gmail.com (mailing list archive)
State Accepted
Commit e3516bb45078fbcafeefe20a990080b9c838ac72
Delegated to: Netdev Maintainers
Headers show
Series timecard updates for v13 firmware | expand

Checks

Context Check Description
netdev/cover_letter success Link
netdev/fixes_present success Link
netdev/patch_count fail Series longer than 15 patches
netdev/tree_selection success Clearly marked for net-next
netdev/subject_prefix success Link
netdev/cc_maintainers success CCed 3 of 3 maintainers
netdev/source_inline success Was 0 now: 0
netdev/verify_signedoff success Link
netdev/module_param success Was 0 now: 0
netdev/build_32bit success Errors and warnings before: 0 this patch: 0
netdev/kdoc success Errors and warnings before: 0 this patch: 0
netdev/verify_fixes success Link
netdev/checkpatch success total: 0 errors, 0 warnings, 0 checks, 149 lines checked
netdev/build_allmodconfig_warn success Errors and warnings before: 0 this patch: 0
netdev/header_inline success Link

Commit Message

Jonathan Lemon Sept. 15, 2021, 2:16 a.m. UTC
The timecard can provide a NMEA-1083 ZDA (time and date) output
string on a serial port, which can be used to drive other devices.

Add the NMEA resources, and the serial port as a sysfs attribute.

Signed-off-by: Jonathan Lemon <jonathan.lemon@gmail.com>
---
 drivers/ptp/ptp_ocp.c | 57 +++++++++++++++++++++++++++++++++++++++++--
 1 file changed, 55 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/drivers/ptp/ptp_ocp.c b/drivers/ptp/ptp_ocp.c
index 36924423444e..74b5561fbdae 100644
--- a/drivers/ptp/ptp_ocp.c
+++ b/drivers/ptp/ptp_ocp.c
@@ -215,6 +215,7 @@  struct ptp_ocp {
 	struct irig_slave_reg	__iomem *irig_in;
 	struct dcf_master_reg	__iomem *dcf_out;
 	struct dcf_slave_reg	__iomem *dcf_in;
+	struct tod_reg		__iomem *nmea_out;
 	struct ptp_ocp_ext_src	*pps;
 	struct ptp_ocp_ext_src	*ts0;
 	struct ptp_ocp_ext_src	*ts1;
@@ -232,6 +233,7 @@  struct ptp_ocp {
 	int			n_irqs;
 	int			gnss_port;
 	int			mac_port;	/* miniature atomic clock */
+	int			nmea_port;
 	u8			serial[6];
 	bool			has_serial;
 	int			flash_start;
@@ -289,8 +291,9 @@  static int ptp_ocp_ts_enable(void *priv, bool enable);
  * 5: MAC
  * 6: TS2
  * 7: I2C controller
- * 8: HWICAP
+ * 8: HWICAP (notused)
  * 9: SPI Flash
+ * 10: NMEA
  */
 
 static struct ocp_resource ocp_fb_resource[] = {
@@ -353,6 +356,10 @@  static struct ocp_resource ocp_fb_resource[] = {
 		OCP_MEM_RESOURCE(dcf_out),
 		.offset = 0x010A0000, .size = 0x10000,
 	},
+	{
+		OCP_MEM_RESOURCE(nmea_out),
+		.offset = 0x010B0000, .size = 0x10000,
+	},
 	{
 		OCP_MEM_RESOURCE(image),
 		.offset = 0x00020000, .size = 0x1000,
@@ -381,6 +388,10 @@  static struct ocp_resource ocp_fb_resource[] = {
 		OCP_SERIAL_RESOURCE(mac_port),
 		.offset = 0x00180000 + 0x1000, .irq_vec = 5,
 	},
+	{
+		OCP_SERIAL_RESOURCE(nmea_port),
+		.offset = 0x00190000 + 0x1000, .irq_vec = 10,
+	},
 	{
 		OCP_SPI_RESOURCE(spi_flash),
 		.offset = 0x00310000, .size = 0x10000, .irq_vec = 9,
@@ -761,6 +772,8 @@  ptp_ocp_utc_distribute(struct ptp_ocp *bp, u32 val)
 		iowrite32(val, &bp->irig_out->adj_sec);
 	if (bp->dcf_out)
 		iowrite32(val, &bp->dcf_out->adj_sec);
+	if (bp->nmea_out)
+		iowrite32(val, &bp->nmea_out->adj_sec);
 
 	spin_unlock_irqrestore(&bp->lock, flags);
 }
@@ -1272,6 +1285,17 @@  ptp_ocp_register_mem(struct ptp_ocp *bp, struct ocp_resource *r)
 	return 0;
 }
 
+static void
+ptp_ocp_nmea_out_init(struct ptp_ocp *bp)
+{
+	if (!bp->nmea_out)
+		return;
+
+	iowrite32(0, &bp->nmea_out->ctrl);		/* disable */
+	iowrite32(7, &bp->nmea_out->uart_baud);		/* 115200 */
+	iowrite32(1, &bp->nmea_out->ctrl);		/* enable */
+}
+
 /* FB specific board initializers; last "resource" registered. */
 static int
 ptp_ocp_fb_board_init(struct ptp_ocp *bp, struct ocp_resource *r)
@@ -1279,6 +1303,7 @@  ptp_ocp_fb_board_init(struct ptp_ocp *bp, struct ocp_resource *r)
 	bp->flash_start = 1024 * 4096;
 
 	ptp_ocp_tod_init(bp);
+	ptp_ocp_nmea_out_init(bp);
 
 	return ptp_ocp_init_clock(bp);
 }
@@ -1941,6 +1966,13 @@  ptp_ocp_summary_show(struct seq_file *s, void *data)
 			   on ? " ON" : "OFF", val, src);
 	}
 
+	if (bp->nmea_out) {
+		on = ioread32(&bp->nmea_out->ctrl) & 1;
+		val = ioread32(&bp->nmea_out->status);
+		seq_printf(s, "%7s: %s, error: %d\n", "NMEA",
+			   on ? " ON" : "OFF", val);
+	}
+
 	/* compute src for PPS1, used below. */
 	if (bp->pps_select) {
 		val = ioread32(&bp->pps_select->gpio1);
@@ -2069,6 +2101,7 @@  ptp_ocp_device_init(struct ptp_ocp *bp, struct pci_dev *pdev)
 	spin_lock_init(&bp->lock);
 	bp->gnss_port = -1;
 	bp->mac_port = -1;
+	bp->nmea_port = -1;
 	bp->pdev = pdev;
 
 	device_initialize(&bp->dev);
@@ -2134,6 +2167,10 @@  ptp_ocp_complete(struct ptp_ocp *bp)
 		sprintf(buf, "ttyS%d", bp->mac_port);
 		ptp_ocp_link_child(bp, buf, "ttyMAC");
 	}
+	if (bp->nmea_port != -1) {
+		sprintf(buf, "ttyS%d", bp->nmea_port);
+		ptp_ocp_link_child(bp, buf, "ttyNMEA");
+	}
 	sprintf(buf, "ptp%d", ptp_clock_index(bp->ptp));
 	ptp_ocp_link_child(bp, buf, "ptp");
 
@@ -2180,7 +2217,13 @@  ptp_ocp_serial_info(struct device *dev, const char *name, int port, int baud)
 static void
 ptp_ocp_info(struct ptp_ocp *bp)
 {
+	static int nmea_baud[] = {
+		1200, 2400, 4800, 9600, 19200, 38400,
+		57600, 115200, 230400, 460800, 921600,
+		1000000, 2000000
+	};
 	struct device *dev = &bp->pdev->dev;
+	u32 reg;
 
 	ptp_ocp_phc_info(bp);
 	if (bp->tod)
@@ -2199,6 +2242,14 @@  ptp_ocp_info(struct ptp_ocp *bp)
 	}
 	ptp_ocp_serial_info(dev, "GNSS", bp->gnss_port, 115200);
 	ptp_ocp_serial_info(dev, "MAC", bp->mac_port, 57600);
+	if (bp->nmea_out && bp->nmea_port != -1) {
+		int baud = -1;
+
+		reg = ioread32(&bp->nmea_out->uart_baud);
+		if (reg < ARRAY_SIZE(nmea_baud))
+			baud = nmea_baud[reg];
+		ptp_ocp_serial_info(dev, "NMEA", bp->nmea_port, baud);
+	}
 }
 
 static void
@@ -2232,6 +2283,8 @@  ptp_ocp_detach(struct ptp_ocp *bp)
 		serial8250_unregister_port(bp->gnss_port);
 	if (bp->mac_port != -1)
 		serial8250_unregister_port(bp->mac_port);
+	if (bp->nmea_port != -1)
+		serial8250_unregister_port(bp->nmea_port);
 	if (bp->spi_flash)
 		platform_device_unregister(bp->spi_flash);
 	if (bp->i2c_ctrl)
@@ -2278,7 +2331,7 @@  ptp_ocp_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 	 * allow this - if not all of the IRQ's are returned, skip the
 	 * extra devices and just register the clock.
 	 */
-	err = pci_alloc_irq_vectors(pdev, 1, 10, PCI_IRQ_MSI | PCI_IRQ_MSIX);
+	err = pci_alloc_irq_vectors(pdev, 1, 11, PCI_IRQ_MSI | PCI_IRQ_MSIX);
 	if (err < 0) {
 		dev_err(&pdev->dev, "alloc_irq_vectors err: %d\n", err);
 		goto out;