@@ -1151,7 +1151,10 @@ static void xgbe_phy_sfp_parse_eeprom(struct xgbe_prv_data *pdata)
}
/* Determine the type of SFP */
- if (sfp_base[XGBE_SFP_BASE_10GBE_CC] & XGBE_SFP_BASE_10GBE_CC_SR)
+ if (phy_data->sfp_cable == XGBE_SFP_CABLE_PASSIVE &&
+ xgbe_phy_sfp_bit_rate(sfp_eeprom, XGBE_SFP_SPEED_10000))
+ phy_data->sfp_base = XGBE_SFP_BASE_10000_CR;
+ else if (sfp_base[XGBE_SFP_BASE_10GBE_CC] & XGBE_SFP_BASE_10GBE_CC_SR)
phy_data->sfp_base = XGBE_SFP_BASE_10000_SR;
else if (sfp_base[XGBE_SFP_BASE_10GBE_CC] & XGBE_SFP_BASE_10GBE_CC_LR)
phy_data->sfp_base = XGBE_SFP_BASE_10000_LR;
@@ -1167,9 +1170,6 @@ static void xgbe_phy_sfp_parse_eeprom(struct xgbe_prv_data *pdata)
phy_data->sfp_base = XGBE_SFP_BASE_1000_CX;
else if (sfp_base[XGBE_SFP_BASE_1GBE_CC] & XGBE_SFP_BASE_1GBE_CC_T)
phy_data->sfp_base = XGBE_SFP_BASE_1000_T;
- else if ((phy_data->sfp_cable == XGBE_SFP_CABLE_PASSIVE) &&
- xgbe_phy_sfp_bit_rate(sfp_eeprom, XGBE_SFP_SPEED_10000))
- phy_data->sfp_base = XGBE_SFP_BASE_10000_CR;
switch (phy_data->sfp_base) {
case XGBE_SFP_BASE_1000_T:
The current XGBE code assumes that offset 6 of EEPROM SFP DAC (passive) cables is NULL. However, some cables (the 5 meter and 7 meter Molex passive cables) have non-zero data at offset 6. Fix the logic by moving the passive cable check above the active checks, so as not to be improperly identified as an active cable. This will fix the issue for any passive cable that advertises 1000Base-CX in offset 6. Fixes: abf0a1c2b26a ("amd-xgbe: Add support for SFP+ modules") Signed-off-by: Raju Rangoju <Raju.Rangoju@amd.com> --- Changes since v1: - Split the changes into two patches. The next patch contains the Vendor specific quirk. - Add a vendor check for Molex cables before assigning bit rate ceiling drivers/net/ethernet/amd/xgbe/xgbe-phy-v2.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)