@@ -1,4 +1,4 @@
-.TH DCB-ETS 8 "6 December 2020" "iproute2" "Linux"
+.TH DCB-APP 8 "6 December 2020" "iproute2" "Linux"
.SH NAME
dcb-app \- show / manipulate application priority table of
the DCB (Data Center Bridging) subsystem
@@ -26,7 +26,7 @@ the DCB (Data Center Bridging) subsystem
.RB "[ " pcp-prio " ]"
.ti -8
-.B dcb ets " { " add " | " del " | " replace " } " dev
+.B dcb app " { " add " | " del " | " replace " } " dev
.RI DEV
.RB "[ " default-prio " " \fIPRIO-LIST\fB " ]"
.RB "[ " ethtype-prio " " \fIET-MAP\fB " ]"
@@ -106,7 +106,7 @@ individual APP 3-tuples through
.B add
and
.B del
-commands. On the other other hand, the command
+commands. On the other hand, the command
.B replace
does what one would typically want in this situation--first adds the new
configuration, and then removes the obsolete one, so that only one
@@ -184,7 +184,7 @@ for details. Keys are DSCP points, values are priorities assigned to
traffic with matching DSCP. DSCP points can be written either directly as
numeric values, or using symbolic names specified in
.B /etc/iproute2/rt_dsfield
-(however note that that file specifies full 8-bit dsfield values, whereas
+(however note that the file specifies full 8-bit dsfield values, whereas
.B dcb app
will only use the higher six bits).
.B dcb app show
@@ -230,7 +230,7 @@ priority 4:
.P
# dcb app replace dev eth0 dscp-prio 24:4
.br
-# dcb app show dev eth0 dscp-prio
+# dcb app -N show dev eth0 dscp-prio
.br
dscp-prio 0:0 24:4 48:6
While referencing the dcb-app manpage, I spotted a few mistakes. Lets fix them. Signed-off-by: Daniel Machon <daniel.machon@microchip.com> --- man/man8/dcb-app.8 | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)