@@ -4466,13 +4466,11 @@ int i40e_ndo_set_vf_port_vlan(struct net_device *netdev, int vf_id,
}
vf = &pf->vf[vf_id];
- vsi = pf->vsi[vf->lan_vsi_idx];
- if (!test_bit(I40E_VF_STATE_INIT, &vf->vf_states)) {
- dev_err(&pf->pdev->dev, "VF %d still in reset. Try again.\n",
- vf_id);
+ if (!i40e_check_vf_init_timeout(vf)) {
ret = -EAGAIN;
goto error_pvid;
}
+ vsi = pf->vsi[vf->lan_vsi_idx];
if (le16_to_cpu(vsi->info.pvid) == vlanprio)
/* duplicate request, so just return success */
@@ -4616,13 +4614,11 @@ int i40e_ndo_set_vf_bw(struct net_device *netdev, int vf_id, int min_tx_rate,
}
vf = &pf->vf[vf_id];
- vsi = pf->vsi[vf->lan_vsi_idx];
- if (!test_bit(I40E_VF_STATE_INIT, &vf->vf_states)) {
- dev_err(&pf->pdev->dev, "VF %d still in reset. Try again.\n",
- vf_id);
+ if (!i40e_check_vf_init_timeout(vf)) {
ret = -EAGAIN;
goto error;
}
+ vsi = pf->vsi[vf->lan_vsi_idx];
ret = i40e_set_bw_limit(vsi, vsi->seid, max_tx_rate);
if (ret)
@@ -4789,9 +4785,7 @@ int i40e_ndo_set_vf_spoofchk(struct net_device *netdev, int vf_id, bool enable)
}
vf = &(pf->vf[vf_id]);
- if (!test_bit(I40E_VF_STATE_INIT, &vf->vf_states)) {
- dev_err(&pf->pdev->dev, "VF %d still in reset. Try again.\n",
- vf_id);
+ if (!i40e_check_vf_init_timeout(vf)) {
ret = -EAGAIN;
goto out;
}
Commit 028daf80117376 ("i40e: Fix attach VF to VM issue") fixed a race between i40e_ndo_set_vf_mac() and i40e_reset_vf() during an attachment of VF device to VM. This issue is not related to setting MAC address only but also VLAN assignment to particular VF because the newer libvirt sets configured MAC address as well as an optional VLAN. The same behavior is also for i40e's .ndo_set_vf_rate and .ndo_set_vf_spoofchk where the callbacks just check if the VF was initialized but not wait for the finish of pending reset. Reproducer: [root@host ~]# virsh attach-interface guest hostdev --managed 0000:02:02.0 --mac 52:54:00:b4:aa:bb error: Failed to attach interface error: Cannot set interface MAC/vlanid to 52:54:00:b4:aa:bb/0 for ifname enp2s0f0 vf 0: Resource temporarily unavailable Fix this issue by using i40e_check_vf_init_timeout() helper to check whether a reset of particular VF was finished in i40e's .ndo_set_vf_vlan, .ndo_set_vf_rate and .ndo_set_vf_spoofchk callbacks. Tested-by: Ma Yuying <yuma@redhat.com> Signed-off-by: Ivan Vecera <ivecera@redhat.com> --- .../net/ethernet/intel/i40e/i40e_virtchnl_pf.c | 16 +++++----------- 1 file changed, 5 insertions(+), 11 deletions(-)