| Message ID | 20230831120004.6919-1-repk@triplefau.lt (mailing list archive) |
|---|---|
| State | Superseded |
| Delegated to: | Netdev Maintainers |
| Headers | show |
| Series | [net] net: stmmac: remove unneeded stmmac_poll_controller | expand |
| Context | Check | Description |
|---|---|---|
| netdev/tree_selection | success | Clearly marked for net |
| netdev/apply | fail | Patch does not apply to net |
On Thu, 31 Aug 2023 14:00:04 +0200 Remi Pommarel wrote: > Using netconsole netpoll_poll_dev could be called from interrupt > context, thus using disable_irq() would cause the following kernel > warning with CONFIG_DEBUG_ATOMIC_SLEEP enabled: Could you rebase this on top of netdev/net? It does not apply: Failed to apply patch: Applying: net: stmmac: remove unneeded stmmac_poll_controller Using index info to reconstruct a base tree... M drivers/net/ethernet/stmicro/stmmac/stmmac_main.c Falling back to patching base and 3-way merge... Auto-merging drivers/net/ethernet/stmicro/stmmac/stmmac_main.c CONFLICT (content): Merge conflict in drivers/net/ethernet/stmicro/stmmac/stmmac_main.c Recorded preimage for 'drivers/net/ethernet/stmicro/stmmac/stmmac_main.c' error: Failed to merge in the changes. hint: Use 'git am --show-current-patch=diff' to see the failed patch Patch failed at 0001 net: stmmac: remove unneeded stmmac_poll_controller When you have resolved this problem, run "git am --continue". If you prefer to skip this patch, run "git am --skip" instead. To restore the original branch and stop patching, run "git am --abort".
On Tue, Sep 05, 2023 at 03:17:51PM -0700, Jakub Kicinski wrote: > On Thu, 31 Aug 2023 14:00:04 +0200 Remi Pommarel wrote: > > Using netconsole netpoll_poll_dev could be called from interrupt > > context, thus using disable_irq() would cause the following kernel > > warning with CONFIG_DEBUG_ATOMIC_SLEEP enabled: > > Could you rebase this on top of netdev/net? It does not apply: Sure will do, thanks.
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 4727f7be4f86..9b5c0ebf0519 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -5938,33 +5938,6 @@ static irqreturn_t stmmac_msi_intr_rx(int irq, void *data) return IRQ_HANDLED; } -#ifdef CONFIG_NET_POLL_CONTROLLER -/* Polling receive - used by NETCONSOLE and other diagnostic tools - * to allow network I/O with interrupts disabled. - */ -static void stmmac_poll_controller(struct net_device *dev) -{ - struct stmmac_priv *priv = netdev_priv(dev); - int i; - - /* If adapter is down, do nothing */ - if (test_bit(STMMAC_DOWN, &priv->state)) - return; - - if (priv->plat->multi_msi_en) { - for (i = 0; i < priv->plat->rx_queues_to_use; i++) - stmmac_msi_intr_rx(0, &priv->dma_conf.rx_queue[i]); - - for (i = 0; i < priv->plat->tx_queues_to_use; i++) - stmmac_msi_intr_tx(0, &priv->dma_conf.tx_queue[i]); - } else { - disable_irq(dev->irq); - stmmac_interrupt(dev->irq, dev); - enable_irq(dev->irq); - } -} -#endif - /** * stmmac_ioctl - Entry point for the Ioctl * @dev: Device pointer. @@ -6800,9 +6773,6 @@ static const struct net_device_ops stmmac_netdev_ops = { .ndo_eth_ioctl = stmmac_ioctl, .ndo_setup_tc = stmmac_setup_tc, .ndo_select_queue = stmmac_select_queue, -#ifdef CONFIG_NET_POLL_CONTROLLER - .ndo_poll_controller = stmmac_poll_controller, -#endif .ndo_set_mac_address = stmmac_set_mac_address, .ndo_vlan_rx_add_vid = stmmac_vlan_rx_add_vid, .ndo_vlan_rx_kill_vid = stmmac_vlan_rx_kill_vid,
Using netconsole netpoll_poll_dev could be called from interrupt context, thus using disable_irq() would cause the following kernel warning with CONFIG_DEBUG_ATOMIC_SLEEP enabled: BUG: sleeping function called from invalid context at kernel/irq/manage.c:137 in_atomic(): 1, irqs_disabled(): 128, non_block: 0, pid: 10, name: ksoftirqd/0 CPU: 0 PID: 10 Comm: ksoftirqd/0 Tainted: G W 5.15.42-00075-g816b502b2298-dirty #117 Hardware name: aml (r1) (DT) Call trace: dump_backtrace+0x0/0x270 show_stack+0x14/0x20 dump_stack_lvl+0x8c/0xac dump_stack+0x18/0x30 ___might_sleep+0x150/0x194 __might_sleep+0x64/0xbc synchronize_irq+0x8c/0x150 disable_irq+0x2c/0x40 stmmac_poll_controller+0x140/0x1a0 netpoll_poll_dev+0x6c/0x220 netpoll_send_skb+0x308/0x390 netpoll_send_udp+0x418/0x760 write_msg+0x118/0x140 [netconsole] console_unlock+0x404/0x500 vprintk_emit+0x118/0x250 dev_vprintk_emit+0x19c/0x1cc dev_printk_emit+0x90/0xa8 __dev_printk+0x78/0x9c _dev_warn+0xa4/0xbc ath10k_warn+0xe8/0xf0 [ath10k_core] ath10k_htt_txrx_compl_task+0x790/0x7fc [ath10k_core] ath10k_pci_napi_poll+0x98/0x1f4 [ath10k_pci] __napi_poll+0x58/0x1f4 net_rx_action+0x504/0x590 _stext+0x1b8/0x418 run_ksoftirqd+0x74/0xa4 smpboot_thread_fn+0x210/0x3c0 kthread+0x1fc/0x210 ret_from_fork+0x10/0x20 Since [0] .ndo_poll_controller is only needed if driver doesn't or partially use NAPI. Because stmmac does so, stmmac_poll_controller can be removed fixing the above warning. [0] commit ac3d9dd034e5 ("netpoll: make ndo_poll_controller() optional") Cc: <stable@vger.kernel.org> # 5.15.x Signed-off-by: Remi Pommarel <repk@triplefau.lt> --- .../net/ethernet/stmicro/stmmac/stmmac_main.c | 30 ------------------- 1 file changed, 30 deletions(-)