@@ -104,6 +104,7 @@ struct stm32_ops {
int (*parse_data)(struct stm32_dwmac *dwmac,
struct device *dev);
u32 syscfg_eth_mask;
+ bool clk_rx_enable_in_suspend;
};
static int stm32_dwmac_init(struct plat_stmmacenet_data *plat_dat)
@@ -121,7 +122,8 @@ static int stm32_dwmac_init(struct plat_stmmacenet_data *plat_dat)
if (ret)
return ret;
- if (!dwmac->dev->power.is_suspended) {
+ if (!dwmac->ops->clk_rx_enable_in_suspend ||
+ !dwmac->dev->power.is_suspended) {
ret = clk_prepare_enable(dwmac->clk_rx);
if (ret) {
clk_disable_unprepare(dwmac->clk_tx);
@@ -513,7 +515,8 @@ static struct stm32_ops stm32mp1_dwmac_data = {
.suspend = stm32mp1_suspend,
.resume = stm32mp1_resume,
.parse_data = stm32mp1_parse_data,
- .syscfg_eth_mask = SYSCFG_MP1_ETH_MASK
+ .syscfg_eth_mask = SYSCFG_MP1_ETH_MASK,
+ .clk_rx_enable_in_suspend = true
};
static const struct of_device_id stm32_dwmac_match[] = {
The STM32MP1 keeps clk_rx enabled during suspend, and therefore the driver does not enable the clock in stm32_dwmac_init() if the device was suspended. The problem is that this same code runs on STM32 MCUs, which do disable clk_rx during suspend, causing the clock to never be re-enabled on resume. This patch adds a variant flag to indicate that clk_rx remains enabled during suspend, and uses this to decide whether to enable the clock in stm32_dwmac_init() if the device was suspended. Fixes: 6528e02cc9ff ("net: ethernet: stmmac: add adaptation for stm32mp157c.") Signed-off-by: Ben Wolsieffer <ben.wolsieffer@hefring.com> --- drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-)