@@ -505,6 +505,21 @@ static void aqr107_chip_info(struct phy_device *phydev)
fw_major, fw_minor, build_id, prov_id);
}
+static void aqr107_validate_mode(struct phy_device *phydev,
+ phy_interface_t dts_mode)
+{
+ int ret;
+
+ /* Get the actual PHY mode */
+ ret = aqr107_read_status(phydev);
+ if (ret)
+ return;
+
+ if (dts_mode != phydev->interface)
+ phydev_info(phydev, "%s mode is set in DTS while %s mode is actual. Please update your devicetree.\n",
+ phy_modes(dts_mode), phy_modes(phydev->interface));
+}
+
static int aqr107_config_init(struct phy_device *phydev)
{
int ret;
@@ -528,6 +543,8 @@ static int aqr107_config_init(struct phy_device *phydev)
if (!ret)
aqr107_chip_info(phydev);
+ aqr107_validate_mode(phydev, phydev->interface);
+
return aqr107_set_downshift(phydev, MDIO_AN_VEND_PROV_DOWNSHIFT_DFLT);
}
The Aquantia driver is not setting the PHY mode itself, but it does however still check if the PHY mode set in DTS is one of the supported modes. However, the set PHY mode does not have to match the actual one, so lets add update the PHY mode during .config_init and warn if they differ. Signed-off-by: Robert Marko <robimarko@gmail.com> --- drivers/net/phy/aquantia/aquantia_main.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)