@@ -943,9 +943,7 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
val &= ~MHWTRAP_P5_DIS;
break;
default:
- dev_err(ds->dev, "Unsupported p5_intf_sel %d\n",
- priv->p5_intf_sel);
- goto unlock_exit;
+ break;
}
/* Setup RGMII settings */
@@ -975,7 +973,6 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
dev_dbg(ds->dev, "Setup P5, HWTRAP=0x%x, intf_sel=%s, phy-mode=%s\n",
val, p5_intf_modes(priv->p5_intf_sel), phy_modes(interface));
-unlock_exit:
mutex_unlock(&priv->reg_mutex);
}
There're two code paths for setting up port 5: mt7530_setup() -> mt7530_setup_port5() mt753x_phylink_mac_config() -> mt753x_mac_config() -> mt7530_mac_config() -> mt7530_setup_port5() On the first code path, priv->p5_intf_sel is either set to P5_INTF_SEL_PHY_P0 or P5_INTF_SEL_PHY_P4 when mt7530_setup_port5() is run. On the second code path, priv->p5_intf_sel is set to P5_INTF_SEL_GMAC5 when mt7530_setup_port5() is run. Empty the default case which will never run but is needed nonetheless to handle all the remaining enumeration values. Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com> Reviewed-by: Vladimir Oltean <olteanv@gmail.com> --- drivers/net/dsa/mt7530.c | 5 +---- 1 file changed, 1 insertion(+), 4 deletions(-)