@@ -54,6 +54,9 @@ int ksz8_reset_switch(struct ksz_device *dev);
int ksz8_switch_init(struct ksz_device *dev);
void ksz8_switch_exit(struct ksz_device *dev);
int ksz8_change_mtu(struct ksz_device *dev, int port, int mtu);
+int ksz8_pme_write8(struct ksz_device *dev, u32 reg, u8 value);
+int ksz8_pme_pread8(struct ksz_device *dev, int port, int offset, u8 *data);
+int ksz8_pme_pwrite8(struct ksz_device *dev, int port, int offset, u8 data);
void ksz8_phylink_mac_link_up(struct phylink_config *config,
struct phy_device *phydev, unsigned int mode,
phy_interface_t interface, int speed, int duplex,
@@ -38,6 +38,20 @@ static void ksz_port_cfg(struct ksz_device *dev, int port, int offset, u8 bits,
bits, set ? bits : 0);
}
+/**
+ * ksz8_ind_write8 - EEE/ACL/PME indirect register write
+ * @dev: The device structure.
+ * @table: Function & table select, register 110.
+ * @addr: Indirect access control, register 111.
+ * @data: The data to be written.
+ *
+ * This function performs an indirect register write for EEE, ACL or
+ * PME switch functionalities. Both 8-bit registers 110 and 111 are
+ * written at once with ksz_write16, using the serial multiple write
+ * functionality.
+ *
+ * Return: 0 on success, or an error code on failure.
+ */
static int ksz8_ind_write8(struct ksz_device *dev, u8 table, u16 addr, u8 data)
{
const u16 *regs;
@@ -58,6 +72,59 @@ static int ksz8_ind_write8(struct ksz_device *dev, u8 table, u16 addr, u8 data)
return ret;
}
+/**
+ * ksz8_ind_read8 - EEE/ACL/PME indirect register read
+ * @dev: The device structure.
+ * @table: Function & table select, register 110.
+ * @addr: Indirect access control, register 111.
+ * @val: The value read.
+ *
+ * This function performs an indirect register read for EEE, ACL or
+ * PME switch functionalities. Both 8-bit registers 110 and 111 are
+ * written at once with ksz_write16, using the serial multiple write
+ * functionality.
+ *
+ * Return: 0 on success, or an error code on failure.
+ */
+static int ksz8_ind_read8(struct ksz_device *dev, u8 table, u16 addr, u8 *val)
+{
+ const u16 *regs;
+ u16 ctrl_addr;
+ int ret = 0;
+
+ regs = dev->info->regs;
+
+ mutex_lock(&dev->alu_mutex);
+
+ ctrl_addr = IND_ACC_TABLE(table | TABLE_READ) | addr;
+ ret = ksz_write16(dev, regs[REG_IND_CTRL_0], ctrl_addr);
+ if (!ret)
+ ret = ksz_read8(dev, regs[REG_IND_BYTE], val);
+
+ mutex_unlock(&dev->alu_mutex);
+
+ return ret;
+}
+
+int ksz8_pme_write8(struct ksz_device *dev, u32 reg, u8 value)
+{
+ return ksz8_ind_write8(dev, (u8)(reg >> 8), (u8)(reg), value);
+}
+
+int ksz8_pme_pread8(struct ksz_device *dev, int port, int offset, u8 *data)
+{
+ u8 table = (u8)(offset >> 8 | (port + 1));
+
+ return ksz8_ind_read8(dev, table, (u8)(offset), data);
+}
+
+int ksz8_pme_pwrite8(struct ksz_device *dev, int port, int offset, u8 data)
+{
+ u8 table = (u8)(offset >> 8 | (port + 1));
+
+ return ksz8_ind_write8(dev, table, (u8)(offset), data);
+}
+
int ksz8_reset_switch(struct ksz_device *dev)
{
if (ksz_is_ksz88x3(dev)) {
@@ -1545,6 +1612,7 @@ static void ksz8795_cpu_interface_select(struct ksz_device *dev, int port)
void ksz8_port_setup(struct ksz_device *dev, int port, bool cpu_port)
{
+ const u16 *regs = dev->info->regs;
struct dsa_switch *ds = dev->ds;
const u32 *masks;
int queues;
@@ -1575,6 +1643,13 @@ void ksz8_port_setup(struct ksz_device *dev, int port, bool cpu_port)
member = BIT(dsa_upstream_port(ds, port));
ksz8_cfg_port_member(dev, port, member);
+
+ /* Disable all WoL options by default. Otherwise
+ * ksz_switch_macaddr_get/put logic will not work properly.
+ * CPU port 4 has no WoL functionality.
+ */
+ if (ksz_is_ksz87xx(dev) && !cpu_port)
+ ksz8_pme_pwrite8(dev, port, regs[REG_PORT_PME_CTRL], 0);
}
static void ksz88x3_config_rmii_clk(struct ksz_device *dev)
@@ -1790,6 +1865,7 @@ int ksz8_enable_stp_addr(struct ksz_device *dev)
int ksz8_setup(struct dsa_switch *ds)
{
struct ksz_device *dev = ds->priv;
+ const u16 *regs = dev->info->regs;
int i;
ds->mtu_enforcement_ingress = true;
@@ -1829,6 +1905,16 @@ int ksz8_setup(struct dsa_switch *ds)
for (i = 0; i < (dev->info->num_vlans / 4); i++)
ksz8_r_vlan_entries(dev, i);
+ /* Make sure PME (WoL) is not enabled. If requested, it will
+ * be enabled by ksz_wol_pre_shutdown(). Otherwise, some PMICs
+ * do not like PME events changes before shutdown. PME only
+ * available on KSZ87xx family.
+ */
+ if (ksz_is_ksz87xx(dev)) {
+ ksz8_pme_write8(dev, regs[REG_SW_PME_CTRL], 0);
+ ksz_rmw8(dev, REG_INT_ENABLE, INT_PME, 0);
+ }
+
return ksz8_handle_global_errata(ds);
}
@@ -307,6 +307,9 @@ static const struct ksz_dev_ops ksz8_dev_ops = {
.init = ksz8_switch_init,
.exit = ksz8_switch_exit,
.change_mtu = ksz8_change_mtu,
+ .pme_write8 = ksz8_pme_write8,
+ .pme_pread8 = ksz8_pme_pread8,
+ .pme_pwrite8 = ksz8_pme_pwrite8,
};
static void ksz9477_phylink_mac_link_up(struct phylink_config *config,
@@ -423,6 +426,9 @@ static const u16 ksz8795_regs[] = {
[S_MULTICAST_CTRL] = 0x04,
[P_XMII_CTRL_0] = 0x06,
[P_XMII_CTRL_1] = 0x06,
+ [REG_SW_PME_CTRL] = 0x8003,
+ [REG_PORT_PME_STATUS] = 0x8003,
+ [REG_PORT_PME_CTRL] = 0x8007,
};
static const u32 ksz8795_masks[] = {
@@ -3752,7 +3758,7 @@ static void ksz_get_wol(struct dsa_switch *ds, int port,
u8 pme_ctrl;
int ret;
- if (!is_ksz9477(dev))
+ if (!is_ksz9477(dev) && !ksz_is_ksz87xx(dev))
return;
if (!dev->wakeup_source)
@@ -3805,7 +3811,7 @@ static int ksz_set_wol(struct dsa_switch *ds, int port,
if (wol->wolopts & ~(WAKE_PHY | WAKE_MAGIC))
return -EINVAL;
- if (!is_ksz9477(dev))
+ if (!is_ksz9477(dev) && !ksz_is_ksz87xx(dev))
return -EOPNOTSUPP;
if (!dev->wakeup_source)
@@ -3905,13 +3911,15 @@ int ksz_handle_wake_reason(struct ksz_device *dev, int port)
*/
static void ksz_wol_pre_shutdown(struct ksz_device *dev, bool *wol_enabled)
{
+ const struct ksz_dev_ops *ops = dev->dev_ops;
const u16 *regs = dev->info->regs;
+ u8 pme_pin_en = PME_ENABLE;
struct dsa_port *dp;
int ret;
*wol_enabled = false;
- if (!is_ksz9477(dev))
+ if (!is_ksz9477(dev) && !ksz_is_ksz87xx(dev))
return;
if (!dev->wakeup_source)
@@ -3920,8 +3928,8 @@ static void ksz_wol_pre_shutdown(struct ksz_device *dev, bool *wol_enabled)
dsa_switch_for_each_user_port(dp, dev->ds) {
u8 pme_ctrl = 0;
- ret = dev->dev_ops->pme_pread8(dev, dp->index,
- regs[REG_PORT_PME_CTRL], &pme_ctrl);
+ ret = ops->pme_pread8(dev, dp->index,
+ regs[REG_PORT_PME_CTRL], &pme_ctrl);
if (!ret && pme_ctrl)
*wol_enabled = true;
@@ -3932,8 +3940,13 @@ static void ksz_wol_pre_shutdown(struct ksz_device *dev, bool *wol_enabled)
}
/* Now we are save to enable PME pin. */
- if (*wol_enabled)
- dev->dev_ops->pme_write8(dev, regs[REG_SW_PME_CTRL], PME_ENABLE);
+ if (*wol_enabled) {
+ if (dev->pme_active_high)
+ pme_pin_en |= PME_POLARITY;
+ ops->pme_write8(dev, regs[REG_SW_PME_CTRL], pme_pin_en);
+ if (ksz_is_ksz87xx(dev))
+ ksz_write8(dev, KSZ8795_REG_INT_EN, KSZ8795_INT_PME_MASK);
+ }
}
static int ksz_port_set_mac_address(struct dsa_switch *ds, int port,
@@ -4643,6 +4656,8 @@ int ksz_switch_register(struct ksz_device *dev)
dev->wakeup_source = of_property_read_bool(dev->dev->of_node,
"wakeup-source");
+ dev->pme_active_high = of_property_read_bool(dev->dev->of_node,
+ "microchip,pme-active-high");
}
ret = dsa_register_switch(dev->ds);
@@ -174,6 +174,7 @@ struct ksz_device {
bool synclko_125;
bool synclko_disable;
bool wakeup_source;
+ bool pme_active_high;
struct vlan_table *vlan_cache;
@@ -712,6 +713,9 @@ static inline bool is_lan937x_tx_phy(struct ksz_device *dev, int port)
#define PME_ENABLE BIT(1)
#define PME_POLARITY BIT(0)
+#define KSZ8795_REG_INT_EN 0x7D
+#define KSZ8795_INT_PME_MASK BIT(4)
+
/* Interrupt */
#define REG_SW_PORT_INT_STATUS__1 0x001B
#define REG_SW_PORT_INT_MASK__1 0x001F