@@ -130,6 +130,41 @@
#define MCHP_RDS_PTP_TSU_HARD_RESET 0xc1
#define MCHP_RDS_PTP_TSU_HARDRESET BIT(0)
+/* PTP GPIO Registers */
+#define MCHP_RDS_PTP_CLK_TRGT_SEC_HI_X(evt) (evt ? 0x1f : 0x15)
+#define MCHP_RDS_PTP_CLK_TRGT_SEC_LO_X(evt) (evt ? 0x20 : 0x16)
+#define MCHP_RDS_PTP_CLK_TRGT_NS_HI_X(evt) (evt ? 0x21 : 0x17)
+#define MCHP_RDS_PTP_CLK_TRGT_NS_LO_X(evt) (evt ? 0x22 : 0x18)
+
+#define MCHP_RDS_PTP_CLK_TRGT_RELOAD_SEC_HI_X(evt) (evt ? 0x23 : 0x19)
+#define MCHP_RDS_PTP_CLK_TRGT_RELOAD_SEC_LO_X(evt) (evt ? 0x24 : 0x1a)
+#define MCHP_RDS_PTP_CLK_TRGT_RELOAD_NS_HI_X(evt) (evt ? 0x25 : 0x1b)
+#define MCHP_RDS_PTP_CLK_TRGT_RELOAD_NS_LO_X(evt) (evt ? 0x26 : 0x1c)
+
+#define MCHP_RDS_PTP_GEN_CFG 0x01
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_X_MASK_(evt) \
+ ((evt) ? GENMASK(11, 8) : GENMASK(7, 4))
+
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_X_SET_(evt, value) \
+ (((value) & 0xF) << (4 + ((evt) << 2)))
+#define MCHP_RDS_PTP_GEN_CFG_RELOAD_ADD_X_(evt) ((evt) ? BIT(2) : BIT(0))
+#define MCHP_RDS_PTP_GEN_CFG_POLARITY_X_(evt) ((evt) ? BIT(3) : BIT(1))
+
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_200MS_ 13
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_100MS_ 12
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_50MS_ 11
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_10MS_ 10
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_5MS_ 9
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_1MS_ 8
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_500US_ 7
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_100US_ 6
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_50US_ 5
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_10US_ 4
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_5US_ 3
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_1US_ 2
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_500NS_ 1
+#define MCHP_RDS_PTP_GEN_CFG_LTC_EVT_100NS_ 0
+
/* Represents 1ppm adjustment in 2^32 format with
* each nsec contains 4 clock cycles in 250MHz.
* The value is calculated as following: (1/1000000)/((2^-32)/4)
@@ -138,6 +173,13 @@
#define MCHP_RDS_PTP_FIFO_SIZE 8
#define MCHP_RDS_PTP_MAX_ADJ 31249999
+#define MCHP_RDS_PTP_EVT_A 0
+#define MCHP_RDS_PTP_EVT_B 1
+#define MCHP_RDS_PTP_BUFFER_TIME 2
+
+#define MCHP_RDS_PTP_N_GPIO 4
+#define MCHP_RDS_PTP_N_PEROUT 2
+
#define BASE_CLK(p) ((p)->clk_base_addr)
#define BASE_PORT(p) ((p)->port_base_addr)
#define PTP_MMD(p) ((p)->mmd)
@@ -176,6 +218,11 @@ struct mchp_rds_ptp_clock {
/* Lock for phc */
struct mutex ptp_lock;
u8 mmd;
+ int mchp_rds_ptp_event_a;
+ int mchp_rds_ptp_event_b;
+ int gpio_event_a;
+ int gpio_event_b;
+ struct ptp_pin_desc *pin_config;
};
struct mchp_rds_ptp_rx_ts {
This ptp header file library changes will cover PEROUT macros that are required to generate periodic output from GPIO Signed-off-by: Divya Koppera <divya.koppera@microchip.com> --- drivers/net/phy/microchip_rds_ptp.h | 47 +++++++++++++++++++++++++++++ 1 file changed, 47 insertions(+)