@@ -442,34 +442,27 @@ static void xrs700x_teardown(struct dsa_switch *ds)
cancel_delayed_work_sync(&priv->mib_work);
}
-static void xrs700x_phylink_validate(struct dsa_switch *ds, int port,
- unsigned long *supported,
- struct phylink_link_state *state)
+static void xrs700x_phylink_get_caps(struct dsa_switch *ds, int port,
+ struct phylink_config *config)
{
- __ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
-
switch (port) {
case 0:
+ __set_bit(PHY_INTERFACE_MODE_RMII,
+ config->supported_interfaces);
+ config->mac_capabilities = MAC_10FD | MAC_100FD;
break;
+
case 1:
case 2:
case 3:
- phylink_set(mask, 1000baseT_Full);
+ phy_interface_set_rgmii(config->supported_interfaces);
+ config->mac_capabilities = MAC_10FD | MAC_100FD | MAC_1000FD;
break;
+
default:
- linkmode_zero(supported);
dev_err(ds->dev, "Unsupported port: %i\n", port);
- return;
+ break;
}
-
- phylink_set_port_modes(mask);
-
- /* The switch only supports full duplex. */
- phylink_set(mask, 10baseT_Full);
- phylink_set(mask, 100baseT_Full);
-
- linkmode_and(supported, supported, mask);
- linkmode_and(state->advertising, state->advertising, mask);
}
static void xrs700x_mac_link_up(struct dsa_switch *ds, int port,
@@ -703,7 +696,7 @@ static const struct dsa_switch_ops xrs700x_ops = {
.setup = xrs700x_setup,
.teardown = xrs700x_teardown,
.port_stp_state_set = xrs700x_port_stp_state_set,
- .phylink_validate = xrs700x_phylink_validate,
+ .phylink_get_caps = xrs700x_phylink_get_caps,
.phylink_mac_link_up = xrs700x_mac_link_up,
.get_strings = xrs700x_get_strings,
.get_sset_count = xrs700x_get_sset_count,
Populate the supported interfaces and MAC capabilities for the xrs700x family of DSA switches and remove the old validate implementation to allow DSA to use phylink_generic_validate() for this switch driver. According to commit ee00b24f32eb ("net: dsa: add Arrow SpeedChips XRS700x driver") the switch supports one RMII port and up to three RGMII ports. This commit assumes that port 0 is the RMII port and the remainder are RGMII. This commit also results in the Autoneg bit being set in the ethtool link modes, which wasn't in the original; if this switch supports RGMII to a 10/100/1G PHY, then surely we want to allow Autoneg on the PHY. Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk> --- drivers/net/dsa/xrs700x/xrs700x.c | 29 +++++++++++------------------ 1 file changed, 11 insertions(+), 18 deletions(-)