@@ -72,6 +72,10 @@ fi
: ${cross_cc_x86_64="x86_64-linux-gnu-gcc"}
: ${cross_cc_cflags_x86_64="-m64"}
+# tricore is special as it doesn't have a compiler
+: ${cross_as_tricore="tricore-as"}
+: ${cross_ld_tricore="tricore-ld"}
+
for target in $target_list; do
arch=${target%%-*}
@@ -247,6 +251,20 @@ for target in $target_list; do
fi
fi
fi
+
+ # Special handling for assembler only tests
+ eval "target_as=\"\${cross_as_$arch}\""
+ eval "target_ld=\"\${cross_ld_$arch}\""
+ if has $target_as && has $target_ld; then
+ case $target in
+ tricore-softmmu)
+ echo "CROSS_CC_GUEST=$target_as" >> $config_target_mak
+ echo "CROSS_AS_GUEST=$target_as" >> $config_target_mak
+ echo "CROSS_LD_GUEST=$target_ld" >> $config_target_mak
+ got_cross_cc=yes
+ ;;
+ esac
+ fi
fi
if test $got_cross_cc = yes; then
Up until this point we only handled local compilers or assumed we had everything in the container. This falls down when we are building QEMU inside the container. This special handling only affects tricore for now but I put it in a case just in case we add any other "special" targets. Setting CROSS_CC_GUEST is a bit of a hack just to ensure the test runs as we gate on a detected compiler even though the Makefile won't actually use it. It also means we display something sane in the configure output. Signed-off-by: Alex Bennée <alex.bennee@linaro.org> Message-Id: <20210720114057.32053-3-alex.bennee@linaro.org> --- tests/tcg/configure.sh | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)