diff mbox series

[v3,3/4] ide/via: don't attempt to set default BAR addresses

Message ID 20231116103355.588580-4-mark.cave-ayland@ilande.co.uk (mailing list archive)
State New, archived
Headers show
Series ide: implement simple legacy/native mode switching for PCI IDE controllers | expand

Commit Message

Mark Cave-Ayland Nov. 16, 2023, 10:33 a.m. UTC
The via-ide device currently attempts to set the default BAR addresses to the
values shown in the datasheet, but this doesn't work for 2 reasons: firstly
BARS 1-4 do not set the bottom 2 bits to PCI_BASE_ADDRESS_SPACE_IO, and
secondly the initial PCI bus reset clears the values of all PCI device BARs
after the device itself has been reset.

Remove the setting of the default BAR addresses from via_ide_reset() to ensure
there is no doubt that these values are never exposed to the guest.

Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
---
 hw/ide/via.c | 5 -----
 1 file changed, 5 deletions(-)

Comments

Philippe Mathieu-Daudé Nov. 16, 2023, 1:14 p.m. UTC | #1
On 16/11/23 11:33, Mark Cave-Ayland wrote:
> The via-ide device currently attempts to set the default BAR addresses to the
> values shown in the datasheet, but this doesn't work for 2 reasons: firstly
> BARS 1-4 do not set the bottom 2 bits to PCI_BASE_ADDRESS_SPACE_IO, and
> secondly the initial PCI bus reset clears the values of all PCI device BARs
> after the device itself has been reset.
> 
> Remove the setting of the default BAR addresses from via_ide_reset() to ensure
> there is no doubt that these values are never exposed to the guest.
> 
> Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
> ---
>   hw/ide/via.c | 5 -----
>   1 file changed, 5 deletions(-)

Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
diff mbox series

Patch

diff --git a/hw/ide/via.c b/hw/ide/via.c
index fff23803a6..87b134083a 100644
--- a/hw/ide/via.c
+++ b/hw/ide/via.c
@@ -132,11 +132,6 @@  static void via_ide_reset(DeviceState *dev)
     pci_set_word(pci_conf + PCI_STATUS, PCI_STATUS_FAST_BACK |
                  PCI_STATUS_DEVSEL_MEDIUM);
 
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_0, 0x000001f0);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_1, 0x000003f4);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_2, 0x00000170);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_3, 0x00000374);
-    pci_set_long(pci_conf + PCI_BASE_ADDRESS_4, 0x0000cc01); /* BMIBA: 20-23h */
     pci_set_long(pci_conf + PCI_INTERRUPT_LINE, 0x0000010e);
 
     /* IDE chip enable, IDE configuration 1/2, IDE FIFO Configuration*/