[0/9] spi: meson-spicc: add support for AXG and G12A variants

Message

Neil Armstrong March 12, 2020, 1:31 p.m. UTC

The SPICC controller in Amlogic AXG & G12A is capable of driving the
CLK/MOSI/SS signal lines through the idle state which avoid the signals
floating in unexpected state, is capable of using linear clock divider
to reach a much fine tuned range of clocks, while the old controller only
uses a power of two clock divider, result at a more coarse clock range and
finally is capable of running at 80M clock.

The SPICC controller in Amlogic G12A takes the source clock from a specific
clock instead of the bus clock and has a different FIFO size and doesn't
handle the RX Half interrupt the same way as GXL & AXG variants. Thus
the burst management is simplified and takes in account a variable FIFO
size.

Now the controller can support frequencies higher than 30MHz, we need
the setup the I/O line delays in regard of the SPI clock frequency.

Neil Armstrong (7):
  spi: meson-spicc: remove unused variables
  spi: meson-spicc: support max 80MHz clock
  spi: meson-spicc: add min sclk for each compatible
  spi: meson-spicc: setup IO line delay
  spi: meson-spicc: adapt burst handling for G12A support
  dt-bindings: spi: amlogic,meson-gx-spicc: add Amlogic G12A compatible
  spi: meson-spicc: add support for Amlogic G12A

Sunny Luo (2):
  spi: meson-spicc: enhance output enable feature
  spi: meson-spicc: add a linear clock divider support

 .../bindings/spi/amlogic,meson-gx-spicc.yaml  |  22 +
 drivers/spi/Kconfig                           |   1 +
 drivers/spi/spi-meson-spicc.c                 | 496 +++++++++++++-----
 3 files changed, 392 insertions(+), 127 deletions(-)