diff mbox

[v2] spi: efm32: properly namespace location property

Message ID 1394829262-28022-1-git-send-email-u.kleine-koenig@pengutronix.de (mailing list archive)
State Accepted
Commit f2bb31057a42cb439161066db615ca73e4438e30
Headers show

Commit Message

Uwe Kleine-König March 14, 2014, 8:34 p.m. UTC
While reviewing an i2c driver for efm32 that needs a similar property
Wolfram Sang pointed out that "location" is a too generic name for
something that is efm32 specific. So add an appropriate namespace and
fall back to the generic name in case of failure.

Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
---
Changes since (implicit) v1, sent with
Message-Id: 1394812888-22697-1-git-send-email-u.kleine-koenig@pengutronix.de:

 - rebase on top of Mark's topic/efm32 branch
 - adapt dt binding doc accordingly
 
 Documentation/devicetree/bindings/spi/efm32-spi.txt | 4 ++--
 drivers/spi/spi-efm32.c                             | 5 ++++-
 2 files changed, 6 insertions(+), 3 deletions(-)

Comments

Mark Brown March 14, 2014, 8:37 p.m. UTC | #1
On Fri, Mar 14, 2014 at 09:34:22PM +0100, Uwe Kleine-König wrote:
> While reviewing an i2c driver for efm32 that needs a similar property
> Wolfram Sang pointed out that "location" is a too generic name for
> something that is efm32 specific. So add an appropriate namespace and
> fall back to the generic name in case of failure.

Applied, thanks.
Wolfram Sang March 24, 2014, 1:42 p.m. UTC | #2
On Fri, Mar 14, 2014 at 09:34:22PM +0100, Uwe Kleine-König wrote:
> While reviewing an i2c driver for efm32 that needs a similar property
> Wolfram Sang pointed out that "location" is a too generic name for
> something that is efm32 specific. So add an appropriate namespace and
> fall back to the generic name in case of failure.
> 
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>

Acked-by: Wolfram Sang <wsa@the-dreams.de>
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/spi/efm32-spi.txt b/Documentation/devicetree/bindings/spi/efm32-spi.txt
index a590ca51be75..25c02ba530da 100644
--- a/Documentation/devicetree/bindings/spi/efm32-spi.txt
+++ b/Documentation/devicetree/bindings/spi/efm32-spi.txt
@@ -8,7 +8,7 @@  Required properties:
 - interrupts: pair specifying rx and tx irq
 - clocks: phandle to the spi clock
 - cs-gpios: see spi-bus.txt
-- location: Value to write to the ROUTE register's LOCATION bitfield to configure the pinmux for the device, see datasheet for values.
+- efm32,location: Value to write to the ROUTE register's LOCATION bitfield to configure the pinmux for the device, see datasheet for values.
 
 Example:
 
@@ -20,7 +20,7 @@  spi1: spi@0x4000c400 { /* USART1 */
 	interrupts = <15 16>;
 	clocks = <&cmu 20>;
 	cs-gpios = <&gpio 51 1>; // D3
-	location = <1>;
+	efm32,location = <1>;
 	status = "ok";
 
 	ks8851@0 {
diff --git a/drivers/spi/spi-efm32.c b/drivers/spi/spi-efm32.c
index 0512fedf1f13..fdb6fce0530b 100644
--- a/drivers/spi/spi-efm32.c
+++ b/drivers/spi/spi-efm32.c
@@ -294,7 +294,10 @@  static void efm32_spi_probe_dt(struct platform_device *pdev,
 	u32 location;
 	int ret;
 
-	ret = of_property_read_u32(np, "location", &location);
+	ret = of_property_read_u32(np, "efm32,location", &location);
+	if (ret)
+		/* fall back to old and (wrongly) generic property "location" */
+		ret = of_property_read_u32(np, "location", &location);
 	if (!ret) {
 		dev_dbg(&pdev->dev, "using location %u\n", location);
 	} else {