diff mbox

[v2] spi: add "spi-lsb-first" to devicetree

Message ID 1396343450-6199-1-git-send-email-B45475@freescale.com (mailing list archive)
State Accepted
Commit cd6339e6ced387ad67b5551dd2931cfd7e8b970b
Headers show

Commit Message

Zhao Qiang April 1, 2014, 9:10 a.m. UTC
add optional property devicetree for SPI slave nodes
into devicetree so that LSB mode can be enabled by devicetree.

Signed-off-by: Zhao Qiang <B45475@freescale.com>
---
changs for v2:
	- remove duplicate "spi-rx-bus-width" 
 Documentation/devicetree/bindings/spi/spi-bus.txt | 2 ++
 drivers/spi/spi.c                                 | 2 ++
 2 files changed, 4 insertions(+)

Comments

Mark Brown April 2, 2014, 7:39 p.m. UTC | #1
On Tue, Apr 01, 2014 at 05:10:50PM +0800, Zhao Qiang wrote:
> add optional property devicetree for SPI slave nodes
> into devicetree so that LSB mode can be enabled by devicetree.

Applied, thanks.
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/spi/spi-bus.txt b/Documentation/devicetree/bindings/spi/spi-bus.txt
index e5a4d1b..22d5740 100644
--- a/Documentation/devicetree/bindings/spi/spi-bus.txt
+++ b/Documentation/devicetree/bindings/spi/spi-bus.txt
@@ -55,6 +55,8 @@  contain the following properties.
     		chip select active high
 - spi-3wire       - (optional) Empty property indicating device requires
     		    3-wire mode.
+- spi-lsb-first   - (optional) Empty property indicating device requires
+		LSB first mode.
 - spi-tx-bus-width - (optional) The bus width(number of data wires) that
                       used for MOSI. Defaults to 1 if not present.
 - spi-rx-bus-width - (optional) The bus width(number of data wires) that
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 23756b0..0a20a90 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1050,6 +1050,8 @@  static void of_register_spi_devices(struct spi_master *master)
 			spi->mode |= SPI_CS_HIGH;
 		if (of_find_property(nc, "spi-3wire", NULL))
 			spi->mode |= SPI_3WIRE;
+		if (of_find_property(nc, "spi-lsb-first", NULL))
+			spi->mode |= SPI_LSB_FIRST;
 
 		/* Device DUAL/QUAD mode */
 		if (!of_property_read_u32(nc, "spi-tx-bus-width", &value)) {