| Message ID | 1423254474-18963-1-git-send-email-linux@roeck-us.net (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/drivers/spi/spi-sc18is602.c b/drivers/spi/spi-sc18is602.c index 237f2e7..c04e601 100644 --- a/drivers/spi/spi-sc18is602.c +++ b/drivers/spi/spi-sc18is602.c @@ -290,7 +290,7 @@ static int sc18is602_probe(struct i2c_client *client, hw->freq = SC18IS602_CLOCK; break; } - master->bus_num = client->adapter->nr; + master->bus_num = np ? -1 : client->adapter->nr; master->mode_bits = SPI_CPHA | SPI_CPOL | SPI_LSB_FIRST; master->bits_per_word_mask = SPI_BPW_MASK(8); master->setup = sc18is602_setup;
The driver currently only supports a single device per I2C bus since it uses the I2C bus number to set the SPI bus number. This makes it impossible to connect more than one chip to a single I2C bus. We don't want to use dynamic bus numbers unconditionally since this would result in every instantiation getting a different bus number starting with 65,535 counting down unless devicetree is configured. If devicetree is configured, however, the SPI bus number is obtained from devicetree data. So we can use dynamic SPI bus numbers in this case. Reported-and-Tested-by: Marco Menchise <marco.menchise@gmail.com> Signed-off-by: Guenter Roeck <linux@roeck-us.net> --- Resend, this time with Mark's correct e-mail address. Sorry for the noise. drivers/spi/spi-sc18is602.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)