diff mbox

[v4,7/7] spi: imx: defer spi initialization, if DMA engine is pending

Message ID 1448666165-7473-8-git-send-email-anton.bondarenko.sama@gmail.com (mailing list archive)
State Superseded
Headers show

Commit Message

Anton Bondarenko Nov. 27, 2015, 11:16 p.m. UTC 
If SPI device supports DMA mode, but DMA controller is not yet
available due to e.g. a delay in the corresponding kernel module
initialization, retry to initialize SPI driver later on instead of
falling back into PIO only mode.

Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy@mentor.com>
Signed-off-by: Anton Bondarenko <anton.bondarenko.sama@gmail.com>
---
 drivers/spi/spi-imx.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)
diff mbox

Patch

diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index aaa32c2..c2edd0f 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -1341,9 +1341,15 @@  static int spi_imx_probe(struct platform_device *pdev)
 	 * Only validated on i.mx6 now, can remove the constrain if validated on
 	 * other chips.
 	 */
-	if (is_imx51_ecspi(spi_imx) &&
-	    spi_imx_sdma_init(&pdev->dev, spi_imx, master))
-		dev_err(&pdev->dev, "dma setup error,use pio instead\n");
+	if (is_imx51_ecspi(spi_imx)) {
+		ret = spi_imx_sdma_init(&pdev->dev, spi_imx, master);
+		if (ret == -EPROBE_DEFER)
+			goto out_clk_put;
+
+		if (ret < 0)
+			dev_err(&pdev->dev, "dma setup error %d, use pio\n",
+				ret);
+	}
 
 	spi_imx->devtype_data->reset(spi_imx);