diff mbox

[v5,2/3] ACPI / gpio: Add irq_type when a gpio is used as an interrupt

Message ID 1449963004-8391-3-git-send-email-christophe-h.ricard@st.com (mailing list archive)
State New, archived
Headers show

Commit Message

Christophe Ricard Dec. 12, 2015, 11:30 p.m. UTC
When a gpio is used as an interrupt in acpi, the irq_type was not
available for device driver.

Make available polarity and triggering information in acpi_find_gpio by
renaming acpi_gpio_info field active_low  to polarity and adding triggering
field (edge/level).
For sanity, in gpiolib.c replace info.active_low by
"info.polarity == GPIO_ACTIVE_LOW".

Set the irq_type if necessary in acpi_dev_gpio_irq_get.

Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com>
---
 drivers/gpio/gpiolib-acpi.c | 28 ++++++++++++++++++++++------
 drivers/gpio/gpiolib.c      |  4 ++--
 drivers/gpio/gpiolib.h      |  6 ++++--
 3 files changed, 28 insertions(+), 10 deletions(-)

Comments

Andy Shevchenko Dec. 13, 2015, 12:35 a.m. UTC | #1
On Sun, Dec 13, 2015 at 1:30 AM, Christophe Ricard
<christophe.ricard@gmail.com> wrote:
> When a gpio is used as an interrupt in acpi, the irq_type was not
> available for device driver.
>
> Make available polarity and triggering information in acpi_find_gpio by
> renaming acpi_gpio_info field active_low  to polarity and adding triggering
> field (edge/level).
> For sanity, in gpiolib.c replace info.active_low by
> "info.polarity == GPIO_ACTIVE_LOW".
>
> Set the irq_type if necessary in acpi_dev_gpio_irq_get.

Same question about types here. If it's not about hardware no need to
have them as u*.


>
> Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com>
> ---
>  drivers/gpio/gpiolib-acpi.c | 28 ++++++++++++++++++++++------
>  drivers/gpio/gpiolib.c      |  4 ++--
>  drivers/gpio/gpiolib.h      |  6 ++++--
>  3 files changed, 28 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/gpio/gpiolib-acpi.c b/drivers/gpio/gpiolib-acpi.c
> index bbcac3a..04aa69e 100644
> --- a/drivers/gpio/gpiolib-acpi.c
> +++ b/drivers/gpio/gpiolib-acpi.c
> @@ -416,9 +416,10 @@ static int acpi_find_gpio(struct acpi_resource *ares, void *data)
>                  * GpioIo is used then the only way to set the flag is
>                  * to use _DSD "gpios" property.
>                  */
> -               if (lookup->info.gpioint)
> -                       lookup->info.active_low =
> -                               agpio->polarity == ACPI_ACTIVE_LOW;
> +               if (lookup->info.gpioint) {
> +                       lookup->info.polarity = agpio->polarity;
> +                       lookup->info.triggering = agpio->triggering;
> +               }
>         }
>
>         return 1;
> @@ -510,7 +511,7 @@ struct gpio_desc *acpi_get_gpiod_by_index(struct acpi_device *adev,
>         if (lookup.desc && info) {
>                 *info = lookup.info;
>                 if (active_low)
> -                       info->active_low = active_low;
> +                       info->polarity = active_low;
>         }
>
>         return lookup.desc ? lookup.desc : ERR_PTR(-ENOENT);
> @@ -530,6 +531,7 @@ struct gpio_desc *acpi_get_gpiod_by_index(struct acpi_device *adev,
>  int acpi_dev_gpio_irq_get(struct acpi_device *adev, int index)
>  {
>         int idx, i;
> +       u32 irq_flags;
>
>         for (i = 0, idx = 0; idx <= index; i++) {
>                 struct acpi_gpio_info info;
> @@ -538,8 +540,22 @@ int acpi_dev_gpio_irq_get(struct acpi_device *adev, int index)
>                 desc = acpi_get_gpiod_by_index(adev, NULL, i, &info);
>                 if (IS_ERR(desc))
>                         break;
> -               if (info.gpioint && idx++ == index)
> -                       return gpiod_to_irq(desc);
> +               if (info.gpioint && idx++ == index) {
> +                       int irq = gpiod_to_irq(desc);
> +
> +                       if (irq < 0)
> +                               return irq;
> +
> +                       irq_flags = acpi_dev_get_irq_type(info.triggering,
> +                                                         info.polarity);
> +
> +                       /* Set type if specified and different than the current one */
> +                       if (irq_flags != IRQ_TYPE_NONE &&
> +                           irq_flags != irq_get_trigger_type(irq))
> +                               irq_set_irq_type(irq, irq_flags);
> +
> +                       return irq;
> +               }
>         }
>         return -ENOENT;
>  }
> diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
> index 6798355..90e737f 100644
> --- a/drivers/gpio/gpiolib.c
> +++ b/drivers/gpio/gpiolib.c
> @@ -1873,7 +1873,7 @@ static struct gpio_desc *acpi_find_gpio(struct device *dev, const char *con_id,
>                         return desc;
>         }
>
> -       if (info.active_low)
> +       if (info.polarity == GPIO_ACTIVE_LOW)
>                 *flags |= GPIO_ACTIVE_LOW;
>
>         return desc;
> @@ -2212,7 +2212,7 @@ struct gpio_desc *fwnode_get_named_gpiod(struct fwnode_handle *fwnode,
>                 desc = acpi_get_gpiod_by_index(to_acpi_node(fwnode), propname, 0,
>                                                &info);
>                 if (!IS_ERR(desc))
> -                       active_low = info.active_low;
> +                       active_low = info.polarity == GPIO_ACTIVE_LOW;
>         }
>
>         if (IS_ERR(desc))
> diff --git a/drivers/gpio/gpiolib.h b/drivers/gpio/gpiolib.h
> index 78e634d..57063d2 100644
> --- a/drivers/gpio/gpiolib.h
> +++ b/drivers/gpio/gpiolib.h
> @@ -22,11 +22,13 @@ struct acpi_device;
>  /**
>   * struct acpi_gpio_info - ACPI GPIO specific information
>   * @gpioint: if %true this GPIO is of type GpioInt otherwise type is GpioIo
> - * @active_low: in case of @gpioint, the pin is active low
> + * @polarity: in case of @gpioint, the pin is active low
> + * @triggering: in case of @gpioint, interrupt triggering mode (edge or level)
>   */
>  struct acpi_gpio_info {
>         bool gpioint;
> -       bool active_low;
> +       u32 polarity;
> +       u32 triggering;
>  };
>
>  /* gpio suffixes used for ACPI and device tree lookup */
> --
> 2.1.4
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-spi" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
diff mbox

Patch

diff --git a/drivers/gpio/gpiolib-acpi.c b/drivers/gpio/gpiolib-acpi.c
index bbcac3a..04aa69e 100644
--- a/drivers/gpio/gpiolib-acpi.c
+++ b/drivers/gpio/gpiolib-acpi.c
@@ -416,9 +416,10 @@  static int acpi_find_gpio(struct acpi_resource *ares, void *data)
 		 * GpioIo is used then the only way to set the flag is
 		 * to use _DSD "gpios" property.
 		 */
-		if (lookup->info.gpioint)
-			lookup->info.active_low =
-				agpio->polarity == ACPI_ACTIVE_LOW;
+		if (lookup->info.gpioint) {
+			lookup->info.polarity = agpio->polarity;
+			lookup->info.triggering = agpio->triggering;
+		}
 	}
 
 	return 1;
@@ -510,7 +511,7 @@  struct gpio_desc *acpi_get_gpiod_by_index(struct acpi_device *adev,
 	if (lookup.desc && info) {
 		*info = lookup.info;
 		if (active_low)
-			info->active_low = active_low;
+			info->polarity = active_low;
 	}
 
 	return lookup.desc ? lookup.desc : ERR_PTR(-ENOENT);
@@ -530,6 +531,7 @@  struct gpio_desc *acpi_get_gpiod_by_index(struct acpi_device *adev,
 int acpi_dev_gpio_irq_get(struct acpi_device *adev, int index)
 {
 	int idx, i;
+	u32 irq_flags;
 
 	for (i = 0, idx = 0; idx <= index; i++) {
 		struct acpi_gpio_info info;
@@ -538,8 +540,22 @@  int acpi_dev_gpio_irq_get(struct acpi_device *adev, int index)
 		desc = acpi_get_gpiod_by_index(adev, NULL, i, &info);
 		if (IS_ERR(desc))
 			break;
-		if (info.gpioint && idx++ == index)
-			return gpiod_to_irq(desc);
+		if (info.gpioint && idx++ == index) {
+			int irq = gpiod_to_irq(desc);
+
+			if (irq < 0)
+				return irq;
+
+			irq_flags = acpi_dev_get_irq_type(info.triggering,
+							  info.polarity);
+
+			/* Set type if specified and different than the current one */
+			if (irq_flags != IRQ_TYPE_NONE &&
+			    irq_flags != irq_get_trigger_type(irq))
+				irq_set_irq_type(irq, irq_flags);
+
+			return irq;
+		}
 	}
 	return -ENOENT;
 }
diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index 6798355..90e737f 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -1873,7 +1873,7 @@  static struct gpio_desc *acpi_find_gpio(struct device *dev, const char *con_id,
 			return desc;
 	}
 
-	if (info.active_low)
+	if (info.polarity == GPIO_ACTIVE_LOW)
 		*flags |= GPIO_ACTIVE_LOW;
 
 	return desc;
@@ -2212,7 +2212,7 @@  struct gpio_desc *fwnode_get_named_gpiod(struct fwnode_handle *fwnode,
 		desc = acpi_get_gpiod_by_index(to_acpi_node(fwnode), propname, 0,
 					       &info);
 		if (!IS_ERR(desc))
-			active_low = info.active_low;
+			active_low = info.polarity == GPIO_ACTIVE_LOW;
 	}
 
 	if (IS_ERR(desc))
diff --git a/drivers/gpio/gpiolib.h b/drivers/gpio/gpiolib.h
index 78e634d..57063d2 100644
--- a/drivers/gpio/gpiolib.h
+++ b/drivers/gpio/gpiolib.h
@@ -22,11 +22,13 @@  struct acpi_device;
 /**
  * struct acpi_gpio_info - ACPI GPIO specific information
  * @gpioint: if %true this GPIO is of type GpioInt otherwise type is GpioIo
- * @active_low: in case of @gpioint, the pin is active low
+ * @polarity: in case of @gpioint, the pin is active low
+ * @triggering: in case of @gpioint, interrupt triggering mode (edge or level)
  */
 struct acpi_gpio_info {
 	bool gpioint;
-	bool active_low;
+	u32 polarity;
+	u32 triggering;
 };
 
 /* gpio suffixes used for ACPI and device tree lookup */