[08/11] spi: fsl-espi: make better use of the RX FIFO

Commit Message

Heiner Kallweit Oct. 2, 2016, 12:23 p.m. UTC

So far an interrupt is triggered whenever there's at least one byte
in the RX FIFO. This results in a unnecessarily high number of
interrupts.
Change this to generate an interrupt if
- RX FIFO is half full (except if all bytes to read fit into the
  RX FIFO anyway)
- end of transfer has been reached

This way the number of interrupts can be significantly reduced.

Signed-off-by: Heiner Kallweit <[e-mail]>
---
 drivers/spi/spi-fsl-espi.c | 11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

Patch

diff --git a/drivers/spi/spi-fsl-espi.c b/drivers/spi/spi-fsl-espi.c
index 5abbb62..10d06f2 100644
--- a/drivers/spi/spi-fsl-espi.c
+++ b/drivers/spi/spi-fsl-espi.c
@@ -55,9 +55,10 @@ 
 #define CSMODE_CG(x)		((x) << 3)
 
 #define FSL_ESPI_FIFO_SIZE	32
+#define FSL_ESPI_RXTHR		15
 
 /* Default mode/csmode for eSPI controller */
-#define SPMODE_INIT_VAL (SPMODE_TXTHR(4) | SPMODE_RXTHR(3))
+#define SPMODE_INIT_VAL (SPMODE_TXTHR(4) | SPMODE_RXTHR(FSL_ESPI_RXTHR))
 #define CSMODE_INIT_VAL (CSMODE_POL_1 | CSMODE_BEF(0) \
 		| CSMODE_AFT(0) | CSMODE_CG(1))
 
@@ -281,6 +282,7 @@  static void fsl_espi_setup_transfer(struct spi_device *spi,
 static int fsl_espi_bufs(struct spi_device *spi, struct spi_transfer *t)
 {
 	struct mpc8xxx_spi *mpc8xxx_spi = spi_master_get_devdata(spi->master);
+	u32 mask;
 	int ret;
 
 	mpc8xxx_spi->rx_len = t->len;
@@ -295,8 +297,11 @@  static int fsl_espi_bufs(struct spi_device *spi, struct spi_transfer *t)
 	fsl_espi_write_reg(mpc8xxx_spi, ESPI_SPCOM,
 		(SPCOM_CS(spi->chip_select) | SPCOM_TRANLEN(t->len - 1)));
 
-	/* enable rx ints */
-	fsl_espi_write_reg(mpc8xxx_spi, ESPI_SPIM, SPIM_RNE);
+	/* enable interrupts */
+	mask = SPIM_DON;
+	if (mpc8xxx_spi->rx_len > FSL_ESPI_FIFO_SIZE)
+		mask |= SPIM_RXT;
+	fsl_espi_write_reg(mpc8xxx_spi, ESPI_SPIM, mask);
 
 	/* Prevent filling the fifo from getting interrupted */
 	spin_lock_irq(&mpc8xxx_spi->lock);