diff mbox series

[05/30] spi: dw: Clear IRQ status on DW SPI controller reset

Message ID 20200920112914.26501-6-Sergey.Semin@baikalelectronics.ru (mailing list archive)
State Superseded
Commit a128f6ecd56a32e559889145003425b0c7d406e3
Headers show
Series spi: dw: Add full Baikal-T1 SPI Controllers support | expand

Commit Message

Serge Semin Sept. 20, 2020, 11:28 a.m. UTC
It turns out the IRQ status isn't cleared after switching the controller
off and getting it back on, which may cause raising false error interrupts
if controller has been unsuccessfully used by, for instance, a bootloader
before the driver is loaded. Let's explicitly clear the interrupts status
in the dedicated controller reset method.

Signed-off-by: Serge Semin <Sergey.Semin@baikalelectronics.ru>
---
 drivers/spi/spi-dw.h | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/spi/spi-dw.h b/drivers/spi/spi-dw.h
index 1ab704d1ebd8..ff77f39047ce 100644
--- a/drivers/spi/spi-dw.h
+++ b/drivers/spi/spi-dw.h
@@ -229,14 +229,15 @@  static inline void spi_umask_intr(struct dw_spi *dws, u32 mask)
 }
 
 /*
- * This does disable the SPI controller, interrupts, and re-enable the
- * controller back. Transmit and receive FIFO buffers are cleared when the
- * device is disabled.
+ * This disables the SPI controller, interrupts, clears the interrupts status,
+ * and re-enable the controller back. Transmit and receive FIFO buffers are
+ * cleared when the device is disabled.
  */
 static inline void spi_reset_chip(struct dw_spi *dws)
 {
 	spi_enable_chip(dws, 0);
 	spi_mask_intr(dws, 0xff);
+	dw_readl(dws, DW_SPI_ICR);
 	spi_enable_chip(dws, 1);
 }