spi: spi.h: fix punctuation & grammar typos

Commit Message

Randy Dunlap March 28, 2024, 4:38 a.m. UTC

Fix various punctuation and grammar typos in <linux/spi/spi.h>.

Signed-off-by: Randy Dunlap <[e-mail]>
---
Cc: Mark Brown <[e-mail]>
Cc: [e-mail]

 include/linux/spi/spi.h |   16 ++++++++--------
 1 file changed, 8 insertions(+), 8 deletions(-)

Patch

diff -- a/include/linux/spi/spi.h b/include/linux/spi/spi.h
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -227,9 +227,9 @@  struct spi_device {
 	struct spi_statistics __percpu	*pcpu_statistics;
 
 	/* Bit mask of the chipselect(s) that the driver need to use from
-	 * the chipselect array.When the controller is capable to handle
+	 * the chipselect array. When the controller is capable of handling
 	 * multiple chip selects & memories are connected in parallel
-	 * then more than one bit need to be set in cs_index_mask.
+	 * then more than one bit needs to be set in cs_index_mask.
 	 */
 	u32			cs_index_mask : SPI_CS_CNT_MAX;
 
@@ -611,8 +611,8 @@  struct spi_controller {
 	};
 
 	/*
-	 * On some hardware transfer / message size may be constrained
-	 * the limit may depend on device transfer settings.
+	 * On some hardware, transfer / message size may be constrained.
+	 * The limit may depend on device transfer settings.
 	 */
 	size_t (*max_transfer_size)(struct spi_device *spi);
 	size_t (*max_message_size)(struct spi_device *spi);
@@ -676,7 +676,7 @@  struct spi_controller {
 	void			(*cleanup)(struct spi_device *spi);
 
 	/*
-	 * Used to enable core support for DMA handling, if can_dma()
+	 * Used to enable core support for DMA handling; if can_dma()
 	 * exists and returns true then the transfer will be mapped
 	 * prior to transfer_one() being called.  The driver should
 	 * not modify or store xfer and dma_tx and dma_rx must be set
@@ -1052,10 +1052,10 @@  struct spi_res {
  * by the results of previous messages and where the whole transaction
  * ends when the chipselect goes inactive.
  *
- * When SPI can transfer in 1x,2x or 4x. It can get this transfer information
+ * When SPI can transfer in 1x, 2x or 4x, it can get this transfer information
  * from device through @tx_nbits and @rx_nbits. In Bi-direction, these
- * two should both be set. User can set transfer mode with SPI_NBITS_SINGLE(1x)
- * SPI_NBITS_DUAL(2x) and SPI_NBITS_QUAD(4x) to support these three transfer.
+ * two should both be set. User can set transfer mode with SPI_NBITS_SINGLE(1x),
+ * SPI_NBITS_DUAL(2x) and SPI_NBITS_QUAD(4x) to support these three transfers.
  *
  * The code that submits an spi_message (and its spi_transfers)
  * to the lower layers is responsible for managing its memory.