[v2,10/10] tpm/st33zp24/dts/st33zp24-spi: Add dts documentation for st33zp24 spi phy

Commit Message

Christophe Ricard Jan. 13, 2015, 10:13 p.m. UTC

Reviewed-by: Jasob Gunthorpe <[e-mail]>
Signed-off-by: Christophe Ricard <[e-mail]>
---
 .../bindings/security/tpm/st33zp24-spi.txt         | 34 ++++++++++++++++++++++
 1 file changed, 34 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/security/tpm/st33zp24-spi.txt

Comments

Peter Huewe Jan. 17, 2015, 1:20 p.m. UTC | #1

Am Dienstag, 13. Januar 2015, 23:13:18 schrieb Christophe Ricard:
> +Example (for ARM-based BeagleBoard xM with ST33ZP24 on SPI2):
> +
> +&i2c2 {
^^^^^^^

I2C for SPI?!
Doubt this is correct :)


> +
> +        status = "okay";
> +
> +        st33zp24@0 {
> +

Peter

------------------------------------------------------------------------------
New Year. New Location. New Benefits. New Data Center in Ashburn, VA.
GigeNET is offering a free month of service with a new server in Ashburn.
Choose from 2 high performing configs, both with 100TB of bandwidth.
Higher redundancy.Lower latency.Increased capacity.Completely compliant.
http://p.sf.net/sfu/gigenet

Patch

diff --git a/Documentation/devicetree/bindings/security/tpm/st33zp24-spi.txt b/Documentation/devicetree/bindings/security/tpm/st33zp24-spi.txt
new file mode 100644
index 0000000..923c55d
--- /dev/null
+++ b/Documentation/devicetree/bindings/security/tpm/st33zp24-spi.txt
@@ -0,0 +1,34 @@ 
+* STMicroelectronics SAS. ST33ZP24 TPM SoC
+
+Required properties:
+- compatible: Should be "st,st33zp24-spi".
+- spi-max-frequency: Maximum SPI frequency (<= 10000000).
+
+Optional ST33ZP24 Properties:
+- interrupt-parent: phandle for the interrupt gpio controller
+- interrupts: GPIO interrupt to which the chip is connected
+- lpcpd-gpios: Output GPIO pin used for ST33ZP24 power management D1/D2 state.
+If set, power must be present when the platform is going into sleep/hibernate mode.
+
+Optional SoC Specific Properties:
+- pinctrl-names: Contains only one value - "default".
+- pintctrl-0: Specifies the pin control groups used for this controller.
+
+Example (for ARM-based BeagleBoard xM with ST33ZP24 on SPI2):
+
+&i2c2 {
+
+        status = "okay";
+
+        st33zp24@0 {
+
+                compatible = "st,st33zp24-spi";
+
+                spi-max-frequency = <10000000>;
+
+                interrupt-parent = <&gpio5>;
+                interrupts = <7 IRQ_TYPE_LEVEL_HIGH>;
+
+                lpcpd-gpios = <&gpio5 15 GPIO_ACTIVE_HIGH>;
+        };
+};