@@ -21,6 +21,8 @@
#include <asm/nospec-branch.h>
#include <xen/interface/elfnote.h>
+#include "../kernel/pgtable_64_helpers.h"
+
__HEAD
/*
@@ -102,8 +104,47 @@ SYM_CODE_START_LOCAL(pvh_start_xen)
btsl $_EFER_LME, %eax
wrmsr
+ mov %ebp, %ebx
+ subl $LOAD_PHYSICAL_ADDR, %ebx /* offset */
+ jz .Lpagetable_done
+
+ /* Fixup page-tables for relocation. */
+ leal rva(pvh_init_top_pgt)(%ebp), %edi
+ movl $512, %ecx
+2:
+ testl $_PAGE_PRESENT, 0x00(%edi)
+ jz 1f
+ addl %ebx, 0x00(%edi)
+1:
+ addl $8, %edi
+ decl %ecx
+ jnz 2b
+
+ /* L3 ident has a single entry. */
+ leal rva(pvh_level3_ident_pgt)(%ebp), %edi
+ addl %ebx, 0x00(%edi)
+
+ leal rva(pvh_level3_kernel_pgt)(%ebp), %edi
+ addl %ebx, (4096 - 16)(%edi)
+ addl %ebx, (4096 - 8)(%edi)
+
+ /* pvh_level2_ident_pgt is fine - large pages */
+
+ /* pvh_level2_kernel_pgt needs adjustment - large pages */
+ leal rva(pvh_level2_kernel_pgt)(%ebp), %edi
+ movl $512, %ecx
+2:
+ testl $_PAGE_PRESENT, 0x00(%edi)
+ jz 1f
+ addl %ebx, 0x00(%edi)
+1:
+ addl $8, %edi
+ decl %ecx
+ jnz 2b
+
+.Lpagetable_done:
/* Enable pre-constructed page tables. */
- leal rva(init_top_pgt)(%ebp), %eax
+ leal rva(pvh_init_top_pgt)(%ebp), %eax
mov %eax, %cr3
mov $(X86_CR0_PG | X86_CR0_PE), %eax
mov %eax, %cr0
@@ -197,5 +238,67 @@ SYM_DATA_START_LOCAL(early_stack)
.fill BOOT_STACK_SIZE, 1, 0
SYM_DATA_END_LABEL(early_stack, SYM_L_LOCAL, early_stack_end)
+#ifdef CONFIG_X86_64
+/*
+ * Xen PVH needs a set of identity mapped and kernel high mapping
+ * page tables. pvh_start_xen starts running on the identity mapped
+ * page tables, but xen_prepare_pvh calls into the high mapping.
+ * These page tables need to be relocatable and are only used until
+ * startup_64 transitions to init_top_pgt.
+ */
+SYM_DATA_START_PAGE_ALIGNED(pvh_init_top_pgt)
+ .quad pvh_level3_ident_pgt - __START_KERNEL_map + _KERNPG_TABLE_NOENC
+ .org pvh_init_top_pgt + L4_PAGE_OFFSET*8, 0
+ .quad pvh_level3_ident_pgt - __START_KERNEL_map + _KERNPG_TABLE_NOENC
+ .org pvh_init_top_pgt + L4_START_KERNEL*8, 0
+ /* (2^48-(2*1024*1024*1024))/(2^39) = 511 */
+ .quad pvh_level3_kernel_pgt - __START_KERNEL_map + _PAGE_TABLE_NOENC
+SYM_DATA_END(pvh_init_top_pgt)
+
+SYM_DATA_START_PAGE_ALIGNED(pvh_level3_ident_pgt)
+ .quad pvh_level2_ident_pgt - __START_KERNEL_map + _KERNPG_TABLE_NOENC
+ .fill 511, 8, 0
+SYM_DATA_END(pvh_level3_ident_pgt)
+SYM_DATA_START_PAGE_ALIGNED(pvh_level2_ident_pgt)
+ /*
+ * Since I easily can, map the first 1G.
+ * Don't set NX because code runs from these pages.
+ *
+ * Note: This sets _PAGE_GLOBAL despite whether
+ * the CPU supports it or it is enabled. But,
+ * the CPU should ignore the bit.
+ */
+ PMDS(0, __PAGE_KERNEL_IDENT_LARGE_EXEC, PTRS_PER_PMD)
+SYM_DATA_END(pvh_level2_ident_pgt)
+SYM_DATA_START_PAGE_ALIGNED(pvh_level3_kernel_pgt)
+ .fill L3_START_KERNEL,8,0
+ /* (2^48-(2*1024*1024*1024)-((2^39)*511))/(2^30) = 510 */
+ .quad pvh_level2_kernel_pgt - __START_KERNEL_map + _KERNPG_TABLE_NOENC
+ .quad 0 /* no fixmap */
+SYM_DATA_END(pvh_level3_kernel_pgt)
+
+SYM_DATA_START_PAGE_ALIGNED(pvh_level2_kernel_pgt)
+ /*
+ * Kernel high mapping.
+ *
+ * The kernel code+data+bss must be located below KERNEL_IMAGE_SIZE in
+ * virtual address space, which is 1 GiB if RANDOMIZE_BASE is enabled,
+ * 512 MiB otherwise.
+ *
+ * (NOTE: after that starts the module area, see MODULES_VADDR.)
+ *
+ * This table is eventually used by the kernel during normal runtime.
+ * Care must be taken to clear out undesired bits later, like _PAGE_RW
+ * or _PAGE_GLOBAL in some cases.
+ */
+ PMDS(0, __PAGE_KERNEL_LARGE_EXEC, KERNEL_IMAGE_SIZE/PMD_SIZE)
+SYM_DATA_END(pvh_level2_kernel_pgt)
+
+ ELFNOTE(Xen, XEN_ELFNOTE_PHYS32_RELOC,
+ .long CONFIG_PHYSICAL_ALIGN;
+ .long LOAD_PHYSICAL_ADDR;
+ .long KERNEL_IMAGE_SIZE - 1)
+#endif
+
ELFNOTE(Xen, XEN_ELFNOTE_PHYS32_ENTRY,
_ASM_PTR (pvh_start_xen - __START_KERNEL_map))
The PVH entry point is 32bit. For a 64bit kernel, the entry point must switch to 64bit mode, which requires a set of page tables. In the past, PVH used init_top_pgt. This works fine when the kernel is loaded at LOAD_PHYSICAL_ADDR, as the page tables are prebuilt for this address. If the kernel is loaded at a different address, they need to be adjusted. __startup_64() adjusts the prebuilt page tables for the physical load address, but it is 64bit code. The 32bit PVH entry code can't call it to adjust the page tables, so it can't readily be re-used. 64bit PVH entry needs page tables set up for identity map, the kernel high map and the direct map. pvh_start_xen() enters identity mapped. Inside xen_prepare_pvh(), it jumps through a pv_ops function pointer into the highmap. The direct map is used for __va() on the initramfs and other guest physical addresses. Add a dedicated set of prebuild page tables for PVH entry. They are adjusted in assembly before loading. Add XEN_ELFNOTE_PHYS32_RELOC to indicate support for relocation along with the kernel's loading constraints. The maximum load address, KERNEL_IMAGE_SIZE - 1, is determined by a single pvh_level2_ident_pgt page. It could be larger with more pages. Signed-off-by: Jason Andryuk <jason.andryuk@amd.com> --- Instead of adding 5 pages of prebuilt page tables, they could be contructed dynamically in the .bss area. They are then only used for PVH entry and until transitioning to init_top_pgt. The .bss is later cleared. It's safer to add the dedicated pages, so that is done here. --- arch/x86/platform/pvh/head.S | 105 ++++++++++++++++++++++++++++++++++- 1 file changed, 104 insertions(+), 1 deletion(-)