@@ -31,12 +31,15 @@
unsigned int ath10k_debug_mask;
static bool uart_print;
static unsigned int ath10k_p2p;
+static bool skip_otp;
module_param_named(debug_mask, ath10k_debug_mask, uint, 0644);
module_param(uart_print, bool, 0644);
module_param_named(p2p, ath10k_p2p, uint, 0644);
+module_param(skip_otp, bool, 0644);
MODULE_PARM_DESC(debug_mask, "Debugging mask");
MODULE_PARM_DESC(uart_print, "Uart target debugging");
MODULE_PARM_DESC(p2p, "Enable ath10k P2P support");
+MODULE_PARM_DESC(skip_otp, "Skip otp failure for calibration in testmode");
static const struct ath10k_hw_params ath10k_hw_params_list[] = {
{
@@ -280,7 +283,7 @@ static int ath10k_download_and_run_otp(struct ath10k *ar)
ath10k_dbg(ar, ATH10K_DBG_BOOT, "boot otp execute result %d\n", result);
- if (result != 0) {
+ if (!skip_otp && result != 0) {
ath10k_err(ar, "otp calibration failed: %d", result);
return -EINVAL;
}
This patch would help bring up wifi interface with default board data in case of failures in otp download. It is useful for initial caliberation. Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com> --- drivers/net/wireless/ath/ath10k/core.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)