@@ -211,6 +211,7 @@ static int wil_pcie_probe(struct pci_dev *pdev, const struct pci_device_id *id)
dev_err(dev, "wil_if_alloc failed: %d\n", rc);
return rc;
}
+
wil->pdev = pdev;
pci_set_drvdata(pdev, wil);
/* rollback to if_free */
@@ -224,6 +225,21 @@ static int wil_pcie_probe(struct pci_dev *pdev, const struct pci_device_id *id)
}
/* rollback to err_plat */
+ /* device supports 48bit addresses */
+ rc = dma_set_mask_and_coherent(dev, DMA_BIT_MASK(48));
+ if (rc) {
+ dev_err(dev, "dma_set_mask_and_coherent(48) failed: %d\n", rc);
+ rc = dma_set_mask_and_coherent(dev, DMA_BIT_MASK(32));
+ if (rc) {
+ dev_err(dev,
+ "dma_set_mask_and_coherent(32) failed: %d\n",
+ rc);
+ goto err_plat;
+ }
+ } else {
+ wil->use_extended_dma_addr = 1;
+ }
+
rc = pci_enable_device(pdev);
if (rc) {
wil_err(wil,
@@ -107,13 +107,28 @@ void wil_pmc_alloc(struct wil6210_priv *wil,
/* Allocate pring buffer and descriptors.
* vring->va should be aligned on its size rounded up to power of 2
- * This is granted by the dma_alloc_coherent
+ * This is granted by the dma_alloc_coherent.
+ *
+ * HW has limitation that all vrings addresses must share the same
+ * upper 16 msb bits part of 48 bits address. To workaround that,
+ * if we are using 48 bit addresses switch to 32 bit allocation
+ * before allocating vring memory.
+ *
+ * There's no check for the return value of dma_set_mask_and_coherent,
+ * since we assume if we were able to set the mask during
+ * initialization in this system it will not fail if we set it again
*/
+ if (wil->use_extended_dma_addr)
+ dma_set_mask_and_coherent(dev, DMA_BIT_MASK(32));
+
pmc->pring_va = dma_alloc_coherent(dev,
sizeof(struct vring_tx_desc) * num_descriptors,
&pmc->pring_pa,
GFP_KERNEL);
+ if (wil->use_extended_dma_addr)
+ dma_set_mask_and_coherent(dev, DMA_BIT_MASK(48));
+
wil_dbg_misc(wil,
"pmc_alloc: allocated pring %p => %pad. %zd x %d = total %zd bytes\n",
pmc->pring_va, &pmc->pring_pa,
@@ -123,15 +123,32 @@ static int wil_vring_alloc(struct wil6210_priv *wil, struct vring *vring)
vring->va = NULL;
return -ENOMEM;
}
+
/* vring->va should be aligned on its size rounded up to power of 2
- * This is granted by the dma_alloc_coherent
+ * This is granted by the dma_alloc_coherent.
+ *
+ * HW has limitation that all vrings addresses must share the same
+ * upper 16 msb bits part of 48 bits address. To workaround that,
+ * if we are using 48 bit addresses switch to 32 bit allocation
+ * before allocating vring memory.
+ *
+ * There's no check for the return value of dma_set_mask_and_coherent,
+ * since we assume if we were able to set the mask during
+ * initialization in this system it will not fail if we set it again
*/
+ if (wil->use_extended_dma_addr)
+ dma_set_mask_and_coherent(dev, DMA_BIT_MASK(32));
+
vring->va = dma_alloc_coherent(dev, sz, &vring->pa, GFP_KERNEL);
if (!vring->va) {
kfree(vring->ctx);
vring->ctx = NULL;
return -ENOMEM;
}
+
+ if (wil->use_extended_dma_addr)
+ dma_set_mask_and_coherent(dev, DMA_BIT_MASK(48));
+
/* initially, all descriptors are SW owned
* For Tx and Rx, ownership bit is at the same location, thus
* we can use any
@@ -657,6 +657,7 @@ struct wil6210_priv {
u8 vring2cid_tid[WIL6210_MAX_TX_RINGS][2]; /* [0] - CID, [1] - TID */
struct wil_sta_info sta[WIL6210_MAX_CID];
int bcast_vring;
+ bool use_extended_dma_addr; /* indicates whether we are using 48 bits */
/* scan */
struct cfg80211_scan_request *scan_request;