@@ -2938,14 +2938,14 @@ static inline s8 ath10k_get_legacy_rate_idx(struct ath10k *ar, u8 rate)
#define STATS_OP_FMT(name) tx_stats->stats[ATH10K_STATS_TYPE_##name]
- if (txrate->flags == RATE_INFO_FLAGS_VHT_MCS) {
+ if (txrate->flags & RATE_INFO_FLAGS_VHT_MCS) {
STATS_OP_FMT(SUCC).vht[0][mcs] += pstats->succ_bytes;
STATS_OP_FMT(SUCC).vht[1][mcs] += pstats->succ_pkts;
STATS_OP_FMT(FAIL).vht[0][mcs] += pstats->failed_bytes;
STATS_OP_FMT(FAIL).vht[1][mcs] += pstats->failed_pkts;
STATS_OP_FMT(RETRY).vht[0][mcs] += pstats->retry_bytes;
STATS_OP_FMT(RETRY).vht[1][mcs] += pstats->retry_pkts;
- } else if (txrate->flags == RATE_INFO_FLAGS_MCS) {
+ } else if (txrate->flags & RATE_INFO_FLAGS_MCS) {
STATS_OP_FMT(SUCC).ht[0][ht_idx] += pstats->succ_bytes;
STATS_OP_FMT(SUCC).ht[1][ht_idx] += pstats->succ_pkts;
STATS_OP_FMT(FAIL).ht[0][ht_idx] += pstats->failed_bytes;
@@ -2966,7 +2966,7 @@ static inline s8 ath10k_get_legacy_rate_idx(struct ath10k *ar, u8 rate)
if (ATH10K_HW_AMPDU(pstats->flags)) {
tx_stats->ba_fails += ATH10K_HW_BA_FAIL(pstats->flags);
- if (txrate->flags == RATE_INFO_FLAGS_MCS) {
+ if (txrate->flags & RATE_INFO_FLAGS_MCS) {
STATS_OP_FMT(AMPDU).ht[0][ht_idx] +=
pstats->succ_bytes + pstats->retry_bytes;
STATS_OP_FMT(AMPDU).ht[1][ht_idx] +=
In tx_stats debugfs, txrate->flags may contain multiple bits. For example, RATE_INFO_FLAGS_SHORT_GI could be set, and tx stats bytes and packets will be not updated correctly. Fix this issue by using bit operation to check txrate->flags. Tested HW: QCA9984 Tested Firmware: 10.4-3.9.0.1-00007 Signed-off-by: Brandon Huang <yanghuan@codeaurora.org> --- drivers/net/wireless/ath/ath10k/htt_rx.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)