diff mbox series

[v6,1/3] PCI: microchip: Fix outbound address translation tables

Message ID 20240628115923.4133286-2-daire.mcnamara@microchip.com (mailing list archive)
State Superseded
Delegated to: Krzysztof Wilczyński
Headers show
Series Fix address translations on MPFS PCIe controller | expand

Commit Message

Daire McNamara June 28, 2024, 11:59 a.m. UTC
From: Daire McNamara <daire.mcnamara@microchip.com>

On Microchip PolarFire SoC (MPFS) the PCIe Root Port can be behind one of
three general-purpose Fabric Interface Controller (FIC) buses that
encapsulate an AXI-M interface. That FIC is responsible for managing
the translations of the upper 32-bits of the AXI-M address. On MPFS,
the Root Port driver needs to take account of that outbound address
translation done by the parent FIC bus before setting up its own
outbound address translation tables.  In all cases on MPFS,
the remaining outbound address translation tables are 32-bit only.

Limit the outbound address translation tables to 32-bit only.

This necessitates changing a size_t in mc_pcie_setup_window
to a resource_size_t to avoid a compile error on 32-bit platforms.

Fixes: 6f15a9c9f941 ("PCI: microchip: Add Microchip Polarfire PCIe controller driver")
Signed-off-by: Daire McNamara <daire.mcnamara@microchip.com>
Acked-by: Conor Dooley <conor.dooley@microchip.com>
---
 drivers/pci/controller/pcie-microchip-host.c | 12 +++++++-----
 1 file changed, 7 insertions(+), 5 deletions(-)

Comments

Ilpo Järvinen July 8, 2024, 9:04 a.m. UTC | #1
On Fri, 28 Jun 2024, daire.mcnamara@microchip.com wrote:

> From: Daire McNamara <daire.mcnamara@microchip.com>
> 
> On Microchip PolarFire SoC (MPFS) the PCIe Root Port can be behind one of
> three general-purpose Fabric Interface Controller (FIC) buses that
> encapsulate an AXI-M interface. That FIC is responsible for managing
> the translations of the upper 32-bits of the AXI-M address. On MPFS,
> the Root Port driver needs to take account of that outbound address
> translation done by the parent FIC bus before setting up its own
> outbound address translation tables.  In all cases on MPFS,
> the remaining outbound address translation tables are 32-bit only.
> 
> Limit the outbound address translation tables to 32-bit only.
> 
> This necessitates changing a size_t in mc_pcie_setup_window
> to a resource_size_t to avoid a compile error on 32-bit platforms.

Do you really mean "a compile error" here, that is, building 32-bit kernel 
fails during compile stage? If not, it would be good to rephrase this line.

Other than that,

Reviewed-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>

--
 i.

> Fixes: 6f15a9c9f941 ("PCI: microchip: Add Microchip Polarfire PCIe controller driver")
> Signed-off-by: Daire McNamara <daire.mcnamara@microchip.com>
> Acked-by: Conor Dooley <conor.dooley@microchip.com>
> ---
>  drivers/pci/controller/pcie-microchip-host.c | 12 +++++++-----
>  1 file changed, 7 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-microchip-host.c b/drivers/pci/controller/pcie-microchip-host.c
> index 137fb8570ba2..47c397ae515a 100644
> --- a/drivers/pci/controller/pcie-microchip-host.c
> +++ b/drivers/pci/controller/pcie-microchip-host.c
> @@ -23,6 +23,8 @@
>  /* Number of MSI IRQs */
>  #define MC_MAX_NUM_MSI_IRQS			32
>  
> +#define MC_OUTBOUND_TRANS_TBL_MASK		GENMASK(31, 0)
> +
>  /* PCIe Bridge Phy and Controller Phy offsets */
>  #define MC_PCIE1_BRIDGE_ADDR			0x00008000u
>  #define MC_PCIE1_CTRL_ADDR			0x0000a000u
> @@ -933,7 +935,7 @@ static int mc_pcie_init_irq_domains(struct mc_pcie *port)
>  
>  static void mc_pcie_setup_window(void __iomem *bridge_base_addr, u32 index,
>  				 phys_addr_t axi_addr, phys_addr_t pci_addr,
> -				 size_t size)
> +				 resource_size_t size)
>  {
>  	u32 atr_sz = ilog2(size) - 1;
>  	u32 val;
> @@ -983,7 +985,8 @@ static int mc_pcie_setup_windows(struct platform_device *pdev,
>  		if (resource_type(entry->res) == IORESOURCE_MEM) {
>  			pci_addr = entry->res->start - entry->offset;
>  			mc_pcie_setup_window(bridge_base_addr, index,
> -					     entry->res->start, pci_addr,
> +					     entry->res->start & MC_OUTBOUND_TRANS_TBL_MASK,
> +					     pci_addr,
>  					     resource_size(entry->res));
>  			index++;
>  		}
> @@ -1117,9 +1120,8 @@ static int mc_platform_init(struct pci_config_window *cfg)
>  	int ret;
>  
>  	/* Configure address translation table 0 for PCIe config space */
> -	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start,
> -			     cfg->res.start,
> -			     resource_size(&cfg->res));
> +	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start & MC_OUTBOUND_TRANS_TBL_MASK,
> +			     0, resource_size(&cfg->res));
>  
>  	/* Need some fixups in config space */
>  	mc_pcie_enable_msi(port, cfg->win);
diff mbox series

Patch

diff --git a/drivers/pci/controller/pcie-microchip-host.c b/drivers/pci/controller/pcie-microchip-host.c
index 137fb8570ba2..47c397ae515a 100644
--- a/drivers/pci/controller/pcie-microchip-host.c
+++ b/drivers/pci/controller/pcie-microchip-host.c
@@ -23,6 +23,8 @@ 
 /* Number of MSI IRQs */
 #define MC_MAX_NUM_MSI_IRQS			32
 
+#define MC_OUTBOUND_TRANS_TBL_MASK		GENMASK(31, 0)
+
 /* PCIe Bridge Phy and Controller Phy offsets */
 #define MC_PCIE1_BRIDGE_ADDR			0x00008000u
 #define MC_PCIE1_CTRL_ADDR			0x0000a000u
@@ -933,7 +935,7 @@  static int mc_pcie_init_irq_domains(struct mc_pcie *port)
 
 static void mc_pcie_setup_window(void __iomem *bridge_base_addr, u32 index,
 				 phys_addr_t axi_addr, phys_addr_t pci_addr,
-				 size_t size)
+				 resource_size_t size)
 {
 	u32 atr_sz = ilog2(size) - 1;
 	u32 val;
@@ -983,7 +985,8 @@  static int mc_pcie_setup_windows(struct platform_device *pdev,
 		if (resource_type(entry->res) == IORESOURCE_MEM) {
 			pci_addr = entry->res->start - entry->offset;
 			mc_pcie_setup_window(bridge_base_addr, index,
-					     entry->res->start, pci_addr,
+					     entry->res->start & MC_OUTBOUND_TRANS_TBL_MASK,
+					     pci_addr,
 					     resource_size(entry->res));
 			index++;
 		}
@@ -1117,9 +1120,8 @@  static int mc_platform_init(struct pci_config_window *cfg)
 	int ret;
 
 	/* Configure address translation table 0 for PCIe config space */
-	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start,
-			     cfg->res.start,
-			     resource_size(&cfg->res));
+	mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start & MC_OUTBOUND_TRANS_TBL_MASK,
+			     0, resource_size(&cfg->res));
 
 	/* Need some fixups in config space */
 	mc_pcie_enable_msi(port, cfg->win);