diff mbox

[10/16] wl1251: fix channel switching in monitor mode

Message ID 1382819655-30430-11-git-send-email-pali.rohar@gmail.com (mailing list archive)
State Not Applicable, archived
Headers show

Commit Message

Pali Rohár Oct. 26, 2013, 8:34 p.m. UTC 
From: David Gnedt <david.gnedt@davizone.at>

Use the ENABLE_RX command for channel switching when no interface is present
(monitor mode only).
The advantage of ENABLE_RX is that it leaves the tx data path disabled in
firmware, whereas the usual JOIN command seems to transmit some frames at
firmware level.

Signed-off-by: David Gnedt <david.gnedt@davizone.at>
---
 drivers/net/wireless/ti/wl1251/main.c |   15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

Comments

Pavel Machek Oct. 30, 2013, 11:47 a.m. UTC | #1 
On Sat 2013-10-26 22:34:09, Pali Rohár wrote:
> From: David Gnedt <david.gnedt@davizone.at>
> 
> Use the ENABLE_RX command for channel switching when no interface is present
> (monitor mode only).
> The advantage of ENABLE_RX is that it leaves the tx data path disabled in
> firmware, whereas the usual JOIN command seems to transmit some frames at
> firmware level.
> 
> Signed-off-by: David Gnedt <david.gnedt@davizone.at>

Missing signoff, otherwise

Reviewed-by: Pavel Machek <pavel@ucw.cz>
								Pavel
diff mbox

Patch

diff --git a/drivers/net/wireless/ti/wl1251/main.c b/drivers/net/wireless/ti/wl1251/main.c
index 62cb374..7e6b6d1 100644
--- a/drivers/net/wireless/ti/wl1251/main.c
+++ b/drivers/net/wireless/ti/wl1251/main.c
@@ -611,8 +611,19 @@  static int wl1251_op_config(struct ieee80211_hw *hw, u32 changed)
 	if (channel != wl->channel) {
 		wl->channel = channel;
 
-		ret = wl1251_join(wl, wl->bss_type, wl->channel,
-				  wl->beacon_int, wl->dtim_period);
+		/*
+		 * Use ENABLE_RX command for channel switching when no
+		 * interface is present (monitor mode only).
+		 * This leaves the tx path disabled in firmware, whereas
+		 * the usual JOIN command seems to transmit some frames
+		 * at firmware level.
+		 */
+		if (wl->vif == NULL) {
+			ret = wl1251_cmd_data_path_rx(wl, wl->channel, 1);
+		} else {
+			ret = wl1251_join(wl, wl->bss_type, wl->channel,
+					  wl->beacon_int, wl->dtim_period);
+		}
 		if (ret < 0)
 			goto out_sleep;
 	}