| Message ID | 1555489907-30117-3-git-send-email-svishnoi@codeaurora.org (mailing list archive) |
|---|---|
| State | Accepted |
| Commit | 97354f2c432788e3163134df6bb144f4b6289d87 |
| Delegated to: | Kalle Valo |
| Headers | show |
| Series | Add support for MESH 11S for WCN3990 | expand |
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index b73c23d..3eceb67 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -1630,6 +1630,10 @@ static int ath10k_mac_setup_prb_tmpl(struct ath10k_vif *arvif) if (arvif->vdev_type != WMI_VDEV_TYPE_AP) return 0; + /* For mesh, probe response and beacon share the same template */ + if (ieee80211_vif_is_mesh(vif)) + return 0; + prb = ieee80211_proberesp_get(hw, vif); if (!prb) { ath10k_warn(ar, "failed to get probe resp template from mac80211\n");
Currently mac80211 do not support probe response template for mesh point. When WMI_SERVICE_BEACON_OFFLOAD is enabled, host driver tries to configure probe response template for mesh, but it fails because the interface type is not NL80211_IFTYPE_AP but NL80211_IFTYPE_MESH_POINT. To avoid this failure, skip sending probe response template to firmware for mesh point. Tested HW: WCN3990/QCA6174/QCA9984 Signed-off-by: Surabhi Vishnoi <svishnoi@codeaurora.org> --- drivers/net/wireless/ath/ath10k/mac.c | 4 ++++ 1 file changed, 4 insertions(+)