@@ -4572,12 +4572,6 @@ struct wiphy_iftype_akm_suites {
* and probe responses. This value should be set if the driver
* wishes to limit the number of csa counters. Default (0) means
* infinite.
- * @max_adj_channel_rssi_comp: max offset of between the channel on which the
- * frame was sent and the channel on which the frame was heard for which
- * the reported rssi is still valid. If a driver is able to compensate the
- * low rssi when a frame is heard on different channel, then it should set
- * this variable to the maximal offset for which it can compensate.
- * This value should be set in MHz.
* @bss_select_support: bitmask indicating the BSS selection criteria supported
* by the driver in the .connect() callback. The bit position maps to the
* attribute indices defined in &enum nl80211_bss_select_attr.
@@ -4729,7 +4723,6 @@ struct wiphy {
u16 max_ap_assoc_sta;
u8 max_num_csa_counters;
- u8 max_adj_channel_rssi_comp;
u32 bss_select_support;
@@ -201,8 +201,7 @@ ieee80211_bss_info_update(struct ieee80211_local *local,
mgmt->bssid, cbss->bssid);
/* In case the signal is invalid update the status */
- signal_valid = abs(channel->center_freq - cbss->channel->center_freq)
- <= local->hw.wiphy->max_adj_channel_rssi_comp;
+ signal_valid = channel == cbss->channel;
if (!signal_valid)
rx_status->flag |= RX_FLAG_NO_SIGNAL_VAL;
@@ -1434,8 +1434,7 @@ cfg80211_inform_single_bss_data(struct wiphy *wiphy,
}
rcu_assign_pointer(tmp.pub.ies, ies);
- signal_valid = abs(data->chan->center_freq - channel->center_freq) <=
- wiphy->max_adj_channel_rssi_comp;
+ signal_valid = data->chan == channel->center_freq;
res = cfg80211_bss_update(wiphy_to_rdev(wiphy), &tmp, signal_valid, ts);
if (!res)
return NULL;
@@ -1852,8 +1851,7 @@ cfg80211_inform_single_bss_frame_data(struct wiphy *wiphy,
memcpy(tmp.pub.chain_signal, data->chain_signal, IEEE80211_MAX_CHAINS);
ether_addr_copy(tmp.parent_bssid, data->parent_bssid);
- signal_valid = abs(data->chan->center_freq - channel->center_freq) <=
- wiphy->max_adj_channel_rssi_comp;
+ signal_valid = data->chan == channel;
res = cfg80211_bss_update(wiphy_to_rdev(wiphy), &tmp, signal_valid,
jiffies);
if (!res)