diff mbox

[v2,6/8] ath10k: add support to send addba request

Message ID 87387gfco3.fsf@kamboji.qca.qualcomm.com (mailing list archive)
State Not Applicable
Headers show

Commit Message

Kalle Valo Jan. 12, 2015, 11:42 a.m. UTC
Rajkumar Manoharan <rmanohar@qti.qualcomm.com> writes:

> This per-station debugfs entry helps to send addba request in manual
> mode. Need to pass two configuration parameters (tid, buffer size)
> as input.
>
> To send addba,
>
> echo 1 32 >/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/
> 	   stations/XX:XX:XX:XX:XX:XX/addba
>
> Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com>

[...]

> +	ret = sscanf(buf, "%u %u", &tid, &buf_size);
> +	if (ret != 2) {
> +		ath10k_warn(ar, "ex: echo <tid> <buffer size> >addba\n");
> +		return -EINVAL;
> +	}
> +
> +	/* Valid TID values are 0 through 15 */
> +	if (tid > HTT_DATA_TX_EXT_TID_MGMT - 2) {
> +		ath10k_warn(ar, "Invalid TID %u\n", tid);
> +		return -EINVAL;
> +	}

It's preferred that the driver doesn't print anything based on wrong
user input, so I removed these two warning messages:
diff mbox

Patch

--- a/drivers/net/wireless/ath/ath10k/debugfs_sta.c
+++ b/drivers/net/wireless/ath/ath10k/debugfs_sta.c
@@ -97,16 +97,12 @@  static ssize_t ath10k_dbg_sta_write_addba(struct file *file,
        buf[sizeof(buf) - 1] = '\0';
 
        ret = sscanf(buf, "%u %u", &tid, &buf_size);
-       if (ret != 2) {
-               ath10k_warn(ar, "ex: echo <tid> <buffer size> >addba\n");
+       if (ret != 2)
                return -EINVAL;
-       }
 
        /* Valid TID values are 0 through 15 */
-       if (tid > HTT_DATA_TX_EXT_TID_MGMT - 2) {
-               ath10k_warn(ar, "Invalid TID %u\n", tid);
+       if (tid > HTT_DATA_TX_EXT_TID_MGMT - 2)
                return -EINVAL;
-       }
 
        mutex_lock(&ar->conf_mutex);
        if ((ar->state != ATH10K_STATE_ON) ||