@@ -2931,11 +2931,11 @@ static inline s8 ath10k_get_legacy_rate_idx(struct ath10k *ar, u8 rate)
tx_stats = arsta->tx_stats;
gi = test_bit(ATH10K_RATE_INFO_FLAGS_SGI_BIT, &flags);
- ht_idx = txrate->mcs + txrate->nss * 8;
- mcs = txrate->mcs;
+ mcs = ATH10K_HW_MCS_RATE(pstats->ratecode);
bw = txrate->bw;
nss = txrate->nss;
- idx = mcs * 8 + 8 * 10 * nss;
+ ht_idx = mcs + (nss - 1) * 8;
+ idx = mcs * 8 + 8 * 10 * (nss - 1);
idx += bw * 2 + gi;
#define STATS_OP_FMT(name) tx_stats->stats[ATH10K_STATS_TYPE_##name]
ht_idx (ht rate index) and idx (rate table index) are calculated based on mcs index. This mcs index used in the above calculation should be 0-9 for getting the correct ht_idx and idx. Currently the mcs index used for the above calculations is mcs index which can be 0-31 (in case of HT), leading to incorrect rate index and ht index values. Fix the issue by obtaining mcs value from the ratecode reported by firmware and use it for calculating ht_idx and idx (rate-table index). Tested HW: WCN3990 Tested FW: WLAN.HL.3.1-00784-QCAHLSWMTPLZ-1 Fixes: e88975ca37d1 ("ath10k: dump tx stats in rate table format") Signed-off-by: Surabhi Vishnoi <svishnoi@codeaurora.org> --- drivers/net/wireless/ath/ath10k/htt_rx.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)