@@ -61,6 +61,18 @@
status = "disabled";
};
+ /* DDC_I2C: I2C2_SDA/SCL on MXM3 205/207 */
+ i2cddc: i2c@0 {
+ compatible = "i2c-gpio";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_i2c_ddc>;
+ gpios = <&gpio3 16 GPIO_ACTIVE_HIGH /* sda */
+ &gpio2 30 GPIO_ACTIVE_HIGH /* scl */
+ >;
+ i2c-gpio,delay-us = <2>; /* ~100 kHz */
+ status = "disabled";
+ };
+
reg_module_3v3: regulator-module-3v3 {
compatible = "regulator-fixed";
regulator-name = "+V3.3";
@@ -688,6 +700,14 @@
>;
};
+ pinctrl_i2c_ddc: gpioi2cddcgrp {
+ fsl,pins = <
+ /* DDC bitbang */
+ MX6QDL_PAD_EIM_EB2__GPIO2_IO30 0x1b0b0
+ MX6QDL_PAD_EIM_D16__GPIO3_IO16 0x1b0b0
+ >;
+ };
+
pinctrl_i2c1: i2c1grp {
fsl,pins = <
MX6QDL_PAD_CSI0_DAT8__I2C1_SDA 0x4001b8b1
Currently, the DDC signals are controlled by the DWC HDMI I2C master to be used for HDMI (DVI on the Apalis Evaluation Board). However, the Apalis Evaluation board also allows to route the Apalis DDC I2C to the LVDS or the VGA connector. By default, the signal is routed to DVI (HDMI), and therefor the current default settings are sensible. To ease customization and to prepare for carrier boards with other needs, add a GPIO I2C DDC node. E.g. to reroute the Apalis DDC to the VGA connector on the Apalis Evaluation Board, the following changes can be used: vga { ... ddc-i2c-bus = <&i2cddc>; }; &hdmi { /delete-property/ pinctrl-0; }; &i2cddc { status = "okay"; }; Signed-off-by: Stefan Agner <stefan@agner.ch> --- arch/arm/boot/dts/imx6qdl-apalis.dtsi | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)