Show patches with: Submitter = Jon Mason       |    State = Action Required       |   139 patches
« 1 2 »
Patch Series A/R/T S/W/F Date Submitter Delegate State
MAINTAINERS: Remove self from Broadcom SoCs MAINTAINERS: Remove self from Broadcom SoCs - - - --- 2018-09-19 Jon Mason New
[v2,3/3] ARM: dts: NSP: Add USB3 and USB3 PHY to NSP - - - --- 2017-07-31 Jon Mason New
[v2,2/3] ARM: dts: NSP: Rearrage USB entries - - - --- 2017-07-31 Jon Mason New
[v2,1/3] ARM: dts: NSP: Add dma-coherent to relevant DT entries - - - --- 2017-07-31 Jon Mason New
[v2,6/6] arm64: dts: ns2: Add USB3 Support - - - --- 2017-07-26 Jon Mason New
[v2,5/6] phy: Add USB3 PHY support for Broadcom NS2 SoC - - - --- 2017-07-26 Jon Mason New
[v2,4/6] dt-bindings: usb: Add documentation for NS2 IDM USB3 1 - - --- 2017-07-26 Jon Mason New
[v2,3/6] dt-bindings: usb: Add documentation for NS2 ICFG USB3 1 - - --- 2017-07-26 Jon Mason New
[v2,2/6] dt-bindings: usb: Add documentation for NS2 CDRU USB3 1 - - --- 2017-07-26 Jon Mason New
[v2,1/6] dt-bindings: phy: Add documentation for NS2 USB3 PHY 1 - - --- 2017-07-26 Jon Mason New
[3/3] ARM: dts: NSP: Add USB3 and USB3 PHY to NSP - - - --- 2017-07-25 Jon Mason New
[2/3] ARM: dts: NSP: Rearrage USB entries - - - --- 2017-07-25 Jon Mason New
[1/3] ARM: dts: NSP: Add dma-coherent to relevant DT entries - - - --- 2017-07-25 Jon Mason New
net: mdio-mux: bcm-iproc: call mdiobus_free() in error path 1 - - --- 2017-05-08 Jon Mason New
[3/3] arm64: dts: ns2: Add USB3 Support - - - --- 2017-04-28 Jon Mason New
[2/3] phy: Add USB3 PHY support for Broadcom NS2 SoC - - - --- 2017-04-28 Jon Mason New
[1/3] dt-bindings: phy: Add documentation for NS2 USB3 PHY - - - --- 2017-04-28 Jon Mason New
[v3,3/3] ARM: dts: NSP: Add Thermal Support 1 - - --- 2017-04-28 Jon Mason New
[v3,2/3] thermal: broadcom: ns-thermal: default on iProc SoCs - - - --- 2017-04-28 Jon Mason New
[v3,1/3] ARM: BCM: Enable thermal support for NSP SoCs - - - --- 2017-04-28 Jon Mason New
[v2,3/3] ARM: dts: NSP: Add Thermal Support 1 - - --- 2017-04-27 Jon Mason New
[v2,2/3] thermal: broadcom: ns-thermal: default on iProc SoCs - - - --- 2017-04-27 Jon Mason New
[v2,1/3] ARM: BCM: Enable thermal support for iProc SoCs - - - --- 2017-04-27 Jon Mason New
[2/2] ARM: dts: NSP: Add Thermal Support 1 - - --- 2017-04-25 Jon Mason New
[1/2] thermal: broadcom: Allow for NSP to use ns-thermal driver - - - --- 2017-04-25 Jon Mason New
arm64: dts: NS2: Add dma-coherent to relevant DT entries - - - --- 2017-03-21 Jon Mason New
clk: ns2: Correct SDIO bits - - - --- 2017-03-20 Jon Mason New
ARM: dts: NSP: disable i2c DT entry by default - - - --- 2017-03-07 Jon Mason New
ARM: dts: NSP: Add EHCI/OHCI USB nodes to device tree - - - --- 2017-03-07 Jon Mason New
arm64: dts: NS2: convert "ok" to "okay" - - - --- 2017-03-06 Jon Mason New
[v3,2/2] ARM: dts: bcm5301x: Add I2C support to the DT - - - --- 2017-03-06 Jon Mason New
[v3,1/2] ARM: dts: bcm5301x: Add TWD WD Support to DT - - - --- 2017-03-06 Jon Mason New
[v2,3/3] ARM: dts: bcm5301x: Add I2C support to the DT - - - --- 2017-03-03 Jon Mason New
[v2,2/3] ARM: dts: bcm5301x: Add TWD WD Support to DT - - - --- 2017-03-03 Jon Mason New
[v2,1/3] ARM: dts: BCM5301X: Correct GIC_PPI interrupt flags - - - --- 2017-03-03 Jon Mason New
ARM: dts: NSP: GPIO reboot open-source - - - --- 2017-03-01 Jon Mason New
[2/2] ARM: dts: bcm5301x: Add I2C support to the DT - - - --- 2017-02-28 Jon Mason New
[1/2] ARM: dts: bcm5301x: Add TWD WD Support to DT - - - --- 2017-02-28 Jon Mason New
[v2] MAINTAINERS: Add Jon Mason to BCM5301X maintainers 1 - - --- 2017-02-08 Jon Mason New
MAINTAINERS: Add Jon Mason to BCM5301X maintainers 1 - - --- 2017-02-08 Jon Mason New
[2/2] ARM: dts: BCM5301X: convert to iProc QSPI - - - --- 2017-02-08 Jon Mason New
[1/2] ARM: dts: BCM5301X: Add NAND entries to bcm953012k - - - --- 2017-02-08 Jon Mason New
[2/2] ARM: dts: BCM5301X: Fix memory start address - - - --- 2017-02-08 Jon Mason New
[1/2] ARM: dts: BCM5301X: Fix UARTs on bcm953012k - - - --- 2017-02-08 Jon Mason New
[2/2] PCI: Add quirk entry for NS2 PAXC PCI - - - --- 2017-01-27 Jon Mason New
[1/2] PCI: iproc: allow the MPS to be set - - - --- 2017-01-27 Jon Mason New
ARM: dts: NSP: Fix DT ranges error - - - --- 2017-01-12 Jon Mason New
[7/7] ARM: dts: NSP: Add SD/MMC support - - - --- 2016-12-13 Jon Mason New
[6/7] ARM: dts: NSP: Add Ethernet to NSP XMC - - - --- 2016-12-13 Jon Mason New
[5/7] ARM: dts: NSP: Add and enable amac2 - - - --- 2016-12-13 Jon Mason New
[4/7] ARM: dts: NSP: Add BCM958625K switch ports - - - --- 2016-12-13 Jon Mason New
[3/7] ARM: dts: NSP: Add QSPI support to missing boards - - - --- 2016-12-13 Jon Mason New
[2/7] ARM: dts: NSP: Correct NAND partition unit address - - - --- 2016-12-13 Jon Mason New
[1/7] ARM: dts: NSP: DT Clean-ups - - - --- 2016-12-13 Jon Mason New
[2/2] arm64: dts: NS2: add support for XMC form factor - - - --- 2016-12-05 Jon Mason New
[1/2] arm64: dts: NS2: reserve memory for Nitro firmware - - - --- 2016-12-05 Jon Mason New
[2/2] arm64: dts: NS2: enable PAXC on NS2 SVK - - - --- 2016-11-28 Jon Mason New
[1/2] arm64: dts: NS2: enable GICv2m for PAXB/PAXC interfaces - - - --- 2016-11-28 Jon Mason New
[2/2] arm64: dts: NS2: Add PCI PHYs - - - --- 2016-11-17 Jon Mason New
[1/2] arm64: dts: NS2: enable sdio1 - - - --- 2016-11-17 Jon Mason New
[v6,7/7] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-11-04 Jon Mason New
[v6,6/7] net: ethernet: bgmac: add NS2 support 2 1 - --- 2016-11-04 Jon Mason New
[v6,5/7] net: ethernet: bgmac: device tree phy enablement 2 - - --- 2016-11-04 Jon Mason New
[v6,4/7] Documentation: devicetree: net: add NS2 bindings to amac - 1 - --- 2016-11-04 Jon Mason New
[v6,3/7] net: phy: broadcom: Add BCM54810 PHY entry - 2 - --- 2016-11-04 Jon Mason New
[v6,2/7] Documentation: devicetree: add PHY lane swap binding - 2 - --- 2016-11-04 Jon Mason New
[v6,1/7] net: phy: broadcom: add bcm54xx_auxctl_read - 1 - --- 2016-11-04 Jon Mason New
[v5,7/7] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-11-02 Jon Mason New
[v5,6/7] net: ethernet: bgmac: add NS2 support - 1 - --- 2016-11-02 Jon Mason New
[v5,5/7] net: ethernet: bgmac: device tree phy enablement - 1 - --- 2016-11-02 Jon Mason New
[v5,4/7] Documentation: devicetree: net: add NS2 bindings to amac - 1 - --- 2016-11-02 Jon Mason New
[v5,3/7] net: phy: broadcom: Add BCM54810 PHY entry - 2 - --- 2016-11-02 Jon Mason New
[v5,2/7] Documentation: devicetree: add PHY lane swap binding - 2 - --- 2016-11-02 Jon Mason New
[v5,1/7] net: phy: broadcom: add bcm54xx_auxctl_read - 1 - --- 2016-11-02 Jon Mason New
[v4,7/7] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-11-01 Jon Mason New
[v4,6/7] net: ethernet: bgmac: add NS2 support - - - --- 2016-11-01 Jon Mason New
[v4,5/7] net: ethernet: bgmac: device tree phy enablement - - - --- 2016-11-01 Jon Mason New
[v4,4/7] Documentation: devicetree: net: add NS2 bindings to amac - - - --- 2016-11-01 Jon Mason New
[v4,3/7] net: phy: broadcom: Add BCM54810 PHY entry - - - --- 2016-11-01 Jon Mason New
[v4,2/7] Documentation: devicetree: add PHY lane swap binding - - - --- 2016-11-01 Jon Mason New
[v4,1/7] net: phy: broadcom: add bcm54xx_auxctl_read - - - --- 2016-11-01 Jon Mason New
[v3,6/6] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-11-01 Jon Mason New
[v3,5/6] net: ethernet: bgmac: add NS2 support - - - --- 2016-11-01 Jon Mason New
[v3,4/6] net: ethernet: bgmac: device tree phy enablement - - - --- 2016-11-01 Jon Mason New
[v3,3/6] Documentation: devicetree: net: add NS2 bindings to amac - - - --- 2016-11-01 Jon Mason New
[v3,2/6] net: phy: broadcom: Add BCM54810 PHY entry - - - --- 2016-11-01 Jon Mason New
[v3,1/6] net: phy: broadcom: add bcm54xx_auxctl_read - - - --- 2016-11-01 Jon Mason New
[v2,6/6] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-10-28 Jon Mason New
[v2,5/6] net: ethernet: bgmac: add NS2 support - - - --- 2016-10-28 Jon Mason New
[v2,4/6] net: ethernet: bgmac: device tree phy enablement - - - --- 2016-10-28 Jon Mason New
[v2,3/6] Documentation: devicetree: net: add NS2 bindings to amac - - - --- 2016-10-28 Jon Mason New
[v2,2/6] net: phy: broadcom: Add BCM54810 PHY entry - - - --- 2016-10-28 Jon Mason New
[v2,1/6] net: phy: broadcom: add bcm54xx_auxctl_read - - - --- 2016-10-28 Jon Mason New
[5/5] arm64: dts: NS2: add AMAC ethernet support - - - --- 2016-10-26 Jon Mason New
[4/5] net: ethernet: bgmac: add NS2 support - - - --- 2016-10-26 Jon Mason New
[3/5] net: ethernet: bgmac: device tree phy enablement - - - --- 2016-10-26 Jon Mason New
[2/5] Documentation: devicetree: net: add NS2 bindings to amac - - - --- 2016-10-26 Jon Mason New
[1/5] net: phy: broadcom: Add BCM54810 phy entry - - - --- 2016-10-26 Jon Mason New
[11/11] ARM: dts: NSP: Add new DT file for bcm958622hr - - - --- 2016-08-03 Jon Mason New
[10/11] ARM: dts: NSP: Add new DT file for bcm958623hr - - - --- 2016-08-03 Jon Mason New
« 1 2 »