@@ -227,6 +227,9 @@ dtb-$(CONFIG_ARCH_HIX5HD2) += \
dtb-$(CONFIG_ARCH_INTEGRATOR) += \
integratorap.dtb \
integratorcp.dtb
+dtb-$(CONFIG_ARCH_IXP4XX) += \
+ intel-ixp42x-linksys-nslu2.dtb \
+ intel-ixp43x-gateworks-gw2358.dtb
dtb-$(CONFIG_ARCH_KEYSTONE) += \
keystone-k2hk-evm.dtb \
keystone-k2l-evm.dtb \
new file mode 100644
@@ -0,0 +1,109 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Linksys NSLU2
+ */
+
+/dts-v1/;
+
+#include "intel-ixp42x.dtsi"
+#include <dt-bindings/input/input.h>
+
+/ {
+ model = "Linksys NSLU2 (Network Storage Link for USB 2.0 Disk Drives)";
+ compatible = "linksys,nslu2", "intel,ixp42x";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ memory@0 {
+ /* 32 MB SDRAM */
+ device_type = "memory";
+ reg = <0x00000000 0x2000000>;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,115200n8 root=/dev/mtdblock2 rw rootfstype=squashfs,jffs2 rootwait";
+ stdout-path = "uart0:115200n8";
+ };
+
+ aliases {
+ serial0 = &uart0;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+ led-status {
+ label = "nslu2:red:status";
+ gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
+ default-state = "on";
+ linux,default-trigger = "heartbeat";
+ };
+ led-ready {
+ label = "nslu2:green:ready";
+ gpios = <&gpio0 1 GPIO_ACTIVE_HIGH>;
+ default-state = "on";
+ };
+ led-disk-1 {
+ label = "nslu2:green:disk-1";
+ gpios = <&gpio0 3 GPIO_ACTIVE_LOW>;
+ default-state = "off";
+ };
+ led-disk-2 {
+ label = "nslu2:green:disk-2";
+ gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
+ default-state = "off";
+ };
+ };
+
+ gpio_keys {
+ compatible = "gpio-keys";
+
+ button-power {
+ wakeup-source;
+ linux,code = <KEY_POWER>;
+ label = "power";
+ gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>;
+ };
+ button-reset {
+ wakeup-source;
+ linux,code = <KEY_ESC>;
+ label = "reset";
+ gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ i2c {
+ compatible = "i2c-gpio";
+ sda-gpios = <&gpio0 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ scl-gpios = <&gpio0 6 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ rtc@6f {
+ compatible = "xicor,x1205";
+ reg = <0x6f>;
+ };
+ };
+
+ gpio-poweroff {
+ compatible = "gpio-poweroff";
+ gpios = <&gpio0 8 GPIO_ACTIVE_HIGH>;
+ timeout-ms = <5000>;
+ };
+
+ /* The first 16MB region on the expansion bus */
+ flash@50000000 {
+ compatible = "intel,ixp4xx-flash", "cfi-flash";
+ bank-width = <2>;
+ /*
+ * 8 MB of Flash in 0x20000 byte blocks
+ * mapped in at 0x50000000
+ */
+ reg = <0x50000000 0x800000>;
+
+ partitions {
+ compatible = "redboot-fis";
+ /* Eraseblock at 0x7e0000 */
+ fis-index-block = <0x3f>;
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,25 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Intel XScale Network Processors
+ * in the IXP 42x series. This series has 32 interrupts.
+ */
+#include "intel-ixp4xx.dtsi"
+
+/ {
+ soc {
+ interrupt-controller@c8003000 {
+ compatible = "intel,ixp42x-interrupt";
+ };
+
+ /*
+ * This is the USB Device Mode (UDC) controller, which is used
+ * to present the IXP4xx as a device on a USB bus.
+ */
+ usb@c800b000 {
+ compatible = "intel,ixp4xx-udc";
+ reg = <0xc800b000 0x1000>;
+ interrupts = <12 IRQ_TYPE_LEVEL_HIGH>;
+ status = "disabled";
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,94 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Gateworks IXP43x-based Cambria GW2358
+ */
+
+/dts-v1/;
+
+#include "intel-ixp43x.dtsi"
+
+/ {
+ model = "Gateworks Cambria GW2358";
+ compatible = "gateworks,gw2358", "intel,ixp43x";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ memory@0 {
+ /* 128 MB SDRAM */
+ device_type = "memory";
+ reg = <0x00000000 0x8000000>;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,115200n8 root=/dev/mtdblock2 rw rootfstype=squashfs,jffs2 rootwait";
+ stdout-path = "uart0:115200n8";
+ };
+
+ aliases {
+ serial0 = &uart0;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+ led-user {
+ label = "gw2358:green:LED";
+ gpios = <&pld1 0 GPIO_ACTIVE_LOW>;
+ default-state = "on";
+ linux,default-trigger = "heartbeat";
+ };
+ };
+
+
+ i2c {
+ compatible = "i2c-gpio";
+ sda-gpios = <&gpio0 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ scl-gpios = <&gpio0 6 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ hwmon@28 {
+ compatible = "adi,ad7418";
+ reg = <0x28>;
+ };
+ rtc: ds1672@68 {
+ compatible = "dallas,ds1672";
+ reg = <0x68>;
+ };
+ eeprom@51 {
+ compatible = "atmel,24c08";
+ reg = <0x51>;
+ pagesize = <16>;
+ size = <1024>;
+ read-only;
+ };
+ pld0: pld@56 {
+ compatible = "gateworks,pld-gpio";
+ reg = <0x56>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+ /* This PLD just handles the LED and user button */
+ pld1: pld@57 {
+ compatible = "gateworks,pld-gpio";
+ reg = <0x57>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+ };
+
+ flash@50000000 {
+ compatible = "intel,ixp4xx-flash", "cfi-flash";
+ bank-width = <2>;
+ /*
+ * 32 MB of Flash in 0x20000 byte blocks
+ * mapped in at 0x50000000
+ */
+ reg = <0x50000000 0x2000000>;
+
+ partitions {
+ compatible = "redboot-fis";
+ /* Eraseblock at 0x1fe0000 */
+ fis-index-block = <0xff>;
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,15 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Intel XScale Network Processors
+ * in the IXP 43x series. This series has 64 interrupts and adds a few more
+ * peripherals over the 42x series.
+ */
+#include "intel-ixp4xx.dtsi"
+
+/ {
+ soc {
+ interrupt-controller@c8003000 {
+ compatible = "intel,ixp43x-interrupt";
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,34 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Intel XScale Network Processors
+ * in the IXP45x and IXP46x series. This series has 64 interrupts and adds a
+ * few more peripherals over the 42x and 43x series so this extends the
+ * basic IXP4xx DTSI.
+ */
+#include "intel-ixp4xx.dtsi"
+
+/ {
+ soc {
+ interrupt-controller@c8003000 {
+ compatible = "intel,ixp43x-interrupt";
+ };
+
+ /*
+ * This is the USB Device Mode (UDC) controller, which is used
+ * to present the IXP4xx as a device on a USB bus.
+ */
+ usb@c800b000 {
+ compatible = "intel,ixp4xx-udc";
+ reg = <0xc800b000 0x1000>;
+ interrupts = <12 IRQ_TYPE_LEVEL_HIGH>;
+ status = "disabled";
+ };
+
+ i2c@c8011000 {
+ compatible = "intel,ixp4xx-i2c";
+ reg = <0xc8011000 0x18>;
+ interrupts = <33 IRQ_TYPE_LEVEL_HIGH>;
+ status = "disabled";
+ };
+ };
+};
new file mode 100644
@@ -0,0 +1,58 @@
+// SPDX-License-Identifier: ISC
+/*
+ * Device Tree file for Intel XScale Network Processors
+ * in the IXP 4xx series.
+ */
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/gpio/gpio.h>
+
+/ {
+ soc {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ compatible = "simple-bus";
+ interrupt-parent = <&intcon>;
+
+ uart0: serial@c8000000 {
+ compatible = "intel,xscale-uart";
+ reg = <0xc8000000 0x1000>;
+ /*
+ * The reg-offset and reg-shift is a side effect
+ * of running the platform in big endian mode.
+ */
+ reg-offset = <3>;
+ reg-shift = <2>;
+ interrupts = <15 IRQ_TYPE_LEVEL_HIGH>;
+ clock-frequency = <14745600>;
+ no-loopback-test;
+ };
+
+ gpio0: gpio@c8004000 {
+ compatible = "intel,ixp4xx-gpio";
+ reg = <0xc8004000 0x1000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ intcon: interrupt-controller@c8003000 {
+ /*
+ * Note: no compatible string. The subvariant of the
+ * chip needs to define what version it is. The
+ * location of the interrupt controller is fixed in
+ * memory across all variants.
+ */
+ reg = <0xc8003000 0x100>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ timer@c8005000 {
+ compatible = "intel,ixp4xx-timer";
+ reg = <0xc8005000 0x100>;
+ interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
+ };
+ };
+};
This adds a device tree for the IXP4xx-based Linksys NSLU2 and Gateworks GW2358 which encompass the Gateworks Cambria family. These will be the first IXP4xx device tree platforms. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- ChangeLog RFC->v2: - Take out of RFC - Use ISC license on the files, *BSD likes this license --- arch/arm/boot/dts/Makefile | 3 + .../boot/dts/intel-ixp42x-linksys-nslu2.dts | 109 ++++++++++++++++++ arch/arm/boot/dts/intel-ixp42x.dtsi | 25 ++++ .../dts/intel-ixp43x-gateworks-gw2358.dts | 94 +++++++++++++++ arch/arm/boot/dts/intel-ixp43x.dtsi | 15 +++ arch/arm/boot/dts/intel-ixp45x-ixp46x.dtsi | 34 ++++++ arch/arm/boot/dts/intel-ixp4xx.dtsi | 58 ++++++++++ 7 files changed, 338 insertions(+) create mode 100644 arch/arm/boot/dts/intel-ixp42x-linksys-nslu2.dts create mode 100644 arch/arm/boot/dts/intel-ixp42x.dtsi create mode 100644 arch/arm/boot/dts/intel-ixp43x-gateworks-gw2358.dts create mode 100644 arch/arm/boot/dts/intel-ixp43x.dtsi create mode 100644 arch/arm/boot/dts/intel-ixp45x-ixp46x.dtsi create mode 100644 arch/arm/boot/dts/intel-ixp4xx.dtsi