@@ -1,6 +1,6 @@
// SPDX-License-Identifier: GPL-2.0
/*
- * Copyright (C) 2020 Texas Instruments Incorporated - https://www.ti.com/
+ * Copyright (C) 2020-2021 Texas Instruments Incorporated - https://www.ti.com/
*/
/dts-v1/;
@@ -141,6 +141,22 @@ &mailbox0_cluster11 {
status = "disabled";
};
+&mcu_r5fss0_core0 {
+ mboxes = <&mailbox0_cluster0 &mbox_mcu_r5fss0_core0>;
+};
+
+&mcu_r5fss0_core1 {
+ mboxes = <&mailbox0_cluster0 &mbox_mcu_r5fss0_core1>;
+};
+
+&main_r5fss0_core0 {
+ mboxes = <&mailbox0_cluster1 &mbox_main_r5fss0_core0>;
+};
+
+&main_r5fss0_core1 {
+ mboxes = <&mailbox0_cluster1 &mbox_main_r5fss0_core1>;
+};
+
&main_i2c0 {
pinctrl-names = "default";
pinctrl-0 = <&main_i2c0_pins_default>;
Add the required 'mboxes' property to all the R5F processors for the TI J7200 common processor board. The mailboxes and some shared memory are required for running the Remote Processor Messaging (RPMsg) stack between the host processor and each of the R5Fs. The nodes are therefore added in the common k3-j7200-som-p0.dtsi file so that all of these can be co-located. The chosen sub-mailboxes match the values used in the current firmware images. This can be changed, if needed, as per the system integration needs after making appropriate changes on the firmware side as well. Note that any R5F Core1 resources are needed and used only when that R5F cluster is configured for Split-mode. Signed-off-by: Suman Anna <s-anna@ti.com> --- arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-)