diff mbox series

[v2,4/5] arm64: dts: meson: g12a: x96-max: fix PHY deassert timing requirements

Message ID 83c1a57cb99c04dc31098166f0c26073de5e7709.1606828668.git.stefan@agner.ch (mailing list archive)
State New, archived
Headers show
Series [v2,1/5] arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements | expand

Commit Message

Stefan Agner Dec. 1, 2020, 1:21 p.m. UTC
According to the datasheet (Rev. 1.9) the RTL8211F requires at least
72ms "for internal circuits settling time" before accessing the PHY
egisters. On similar boards with the same PHY this fixes an issue where
Ethernet link would not come up when using ip link set down/up.

Fixes: ed5e8f689154 ("arm64: dts: meson: g12a: x96-max: fix the Ethernet PHY reset line")
Signed-off-by: Stefan Agner <stefan@agner.ch>
---
 arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

Comments

Martin Blumenstingl Dec. 5, 2020, 1:14 p.m. UTC | #1
On Tue, Dec 1, 2020 at 2:21 PM Stefan Agner <stefan@agner.ch> wrote:
>
> According to the datasheet (Rev. 1.9) the RTL8211F requires at least
> 72ms "for internal circuits settling time" before accessing the PHY
> egisters. On similar boards with the same PHY this fixes an issue where
> Ethernet link would not come up when using ip link set down/up.
>
> Fixes: ed5e8f689154 ("arm64: dts: meson: g12a: x96-max: fix the Ethernet PHY reset line")
> Signed-off-by: Stefan Agner <stefan@agner.ch>
with the "registers" typo above fixed:
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts b/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
index 1b07c8c06eac..463a72d6bb7c 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
@@ -340,7 +340,7 @@  external_phy: ethernet-phy@0 {
 		eee-broken-1000t;
 
 		reset-assert-us = <10000>;
-		reset-deassert-us = <30000>;
+		reset-deassert-us = <80000>;
 		reset-gpios = <&gpio GPIOZ_15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
 
 		interrupt-parent = <&gpio_intc>;