@@ -110,3 +110,5 @@ dtb-$(CONFIG_ARCH_QCOM) += sm8250-sony-xperia-edo-pdx203.dtb
dtb-$(CONFIG_ARCH_QCOM) += sm8250-sony-xperia-edo-pdx206.dtb
dtb-$(CONFIG_ARCH_QCOM) += sm8350-hdk.dtb
dtb-$(CONFIG_ARCH_QCOM) += sm8350-mtp.dtb
+dtb-$(CONFIG_ARCH_QCOM) += sm8350-sony-xperia-sagami-pdx214.dtb
+dtb-$(CONFIG_ARCH_QCOM) += sm8350-sony-xperia-sagami-pdx215.dtb
new file mode 100644
@@ -0,0 +1,19 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2021, Konrad Dybcio <konrad.dybcio@somainline.org>
+ */
+
+/dts-v1/;
+
+#include "sm8350-sony-xperia-sagami.dtsi"
+
+/ {
+ model = "Sony Xperia 5 III";
+ compatible = "sony,pdx214-generic", "qcom,sm8350";
+};
+
+&framebuffer {
+ width = <1080>;
+ height = <2520>;
+ stride = <(1080 * 4)>;
+};
new file mode 100644
@@ -0,0 +1,13 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2021, Konrad Dybcio <konrad.dybcio@somainline.org>
+ */
+
+/dts-v1/;
+
+#include "sm8350-sony-xperia-sagami.dtsi"
+
+/ {
+ model = "Sony Xperia 1 III";
+ compatible = "sony,pdx215-generic", "qcom,sm8350";
+};
new file mode 100644
@@ -0,0 +1,132 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) 2021, Konrad Dybcio <konrad.dybcio@somainline.org>
+ */
+
+#include "sm8350.dtsi"
+#include "pm8350.dtsi"
+#include "pm8350b.dtsi"
+#include "pm8350c.dtsi"
+#include "pmk8350.dtsi"
+#include "pmr735a.dtsi"
+#include "pmr735b.dtsi"
+
+/ {
+ /*
+ * Yes, you are correct, there is NO MORE {msm,board,pmic}-id on SM8350!
+ * Adding it will cause the bootloader to go crazy and randomly crash
+ * shortly after closing UEFI boot services.. Perhaps that has something
+ * to do with the OS running inside a VM now..?
+ */
+
+ chassis-type = "handset";
+
+ chosen {
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+
+ framebuffer: framebuffer@e1000000 {
+ compatible = "simple-framebuffer";
+ reg = <0 0xe1000000 0 0x2300000>;
+
+ /* The display, even though it's 4K, initializes at 1080-ish p */
+ width = <1096>;
+ height = <2560>;
+ stride = <(1096 * 4)>;
+ format = "a8r8g8b8";
+ /*
+ * That's (going to be) a lot of clocks, but it's necessary due
+ * to unused clk cleanup & no panel driver yet
+ */
+ clocks = <&gcc GCC_DISP_HF_AXI_CLK>,
+ <&gcc GCC_DISP_SF_AXI_CLK>;
+ };
+ };
+
+ gpio-keys {
+ compatible = "gpio-keys";
+
+ /* For reasons still unknown, GAssist key and Camera Focus/Shutter don't work.. */
+
+ vol-down {
+ label = "Volume Down";
+ linux,code = <KEY_VOLUMEDOWN>;
+ gpios = <&pmk8350_gpios 3 GPIO_ACTIVE_LOW>;
+ debounce-interval = <15>;
+ linux,can-disable;
+ gpio-key,wakeup;
+ };
+ };
+
+ reserved-memory {
+ cont_splash_mem: memory@e1000000 {
+ reg = <0 0xe1000000 0 0x2300000>;
+ no-map;
+ };
+
+ ramoops@ffc00000 {
+ compatible = "ramoops";
+ reg = <0 0xffc00000 0 0x100000>;
+ console-size = <0x40000>;
+ record-size = <0x1000>;
+ no-map;
+ };
+ };
+};
+
+&pmk8350_rtc {
+ status = "okay";
+};
+
+&pon_pwrkey {
+ status = "okay";
+};
+
+&pon_resin {
+ status = "okay";
+ linux,code = <KEY_VOLUMEUP>;
+};
+
+&qupv3_id_0 {
+ status = "okay";
+};
+
+&qupv3_id_1 {
+ status = "okay";
+};
+
+&qupv3_id_2 {
+ status = "okay";
+};
+
+&tlmm {
+ gpio-reserved-ranges = <44 4>;
+};
+
+/* BIG WARNING! DO NOT TOUCH UFS, YOUR DEVICE WILL DIE! */
+&ufs_mem_hc { status = "disabled"; };
+&ufs_mem_phy { status = "disabled"; };
+
+/* TODO: Make USB3 work (perhaps needs regulators for higher-current operation?) */
+&usb_1 {
+ status = "okay";
+
+ qcom,select-utmi-as-pipe-clk;
+};
+
+&usb_1_dwc3 {
+ dr_mode = "peripheral";
+
+ maximum-speed = "high-speed";
+ phys = <&usb_1_hsphy>;
+ phy-names = "usb2-phy";
+};
+
+&usb_1_hsphy {
+ status = "okay";
+};
+
+&usb_1_qmpphy {
+ status = "okay";
+};
Add support for SONY Xperia 1 III (PDX215) and 5 III (PDX214) smartphones. Both are based on the SM8350 Sagami platform and feature some really high-end specs, such as: - 4K (1 III / PRO-I) / 1080p (5 III), 120Hz HDR OLED 10-bit panels - USB-C 3.1 with HDMI in (yes, phone as display!) and DP out - 5G - 8 or 12 gigs of ram, 128/256/512 gigs of storage - A 3.5mm headphone jack, a RGB notification LED and a uSD card slot :) - IP65/68 dust/water resistance - Dual front-firing speakers and a lot of microphones - Crazy complex camera hardware (especially on the PRO-I), which includes 4 cameras, an RGBIR sensor and a 3D iToF The aforementioned PRO-I (PDX217) is not supported in this patch, because even though it shares most of the code with 1 III, nobody really has it (yet?) This only adds basic support for booting to a USB shell with a bootloader-enabled display, support for all the awesome hardware listed above will (hopefully) come (hopefully) soon. In order to get a working boot image, you need to run (e.g. for 1 III): cat arch/arm64/boot/Image.gz arch/arm64/boot/dts/qcom/sm8350-sony-xperia-\ sagami-pdx215.dtb > .Image.gz-dtb mkbootimg \ --kernel .Image.gz-dtb \ --ramdisk some_initrd.img \ --pagesize 4096 \ --base 0x0 \ --kernel_offset 0x8000 \ --ramdisk_offset 0x1000000 \ --tags_offset 0x100 \ --cmdline "SOME_CMDLINE" \ --dtb_offset 0x1f00000 \ --header_version 1 \ --os_version 11 \ --os_patch_level 2021-10 \ # or newer -o boot.img-sony-xperia-pdx215 Then, you need to flash it on the device and get rid of all the vendor_boot/dtbo mess: fastboot flash boot boot.img-sony-xperia-pdx215 fastboot erase vendor_boot fastboot flash dtbo emptydtbo.img fastboot reboot Where emptydtbo.img is a tiny file that consists of 2 bytes (all zeroes), doing a "fastboot erase" won't cut it, the bootloader will go crazy and things will fall apart when it tries to overlay random bytes from an empty partition onto a perfectly good appended DTB. Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org> --- arch/arm64/boot/dts/qcom/Makefile | 2 + .../qcom/sm8350-sony-xperia-sagami-pdx214.dts | 19 +++ .../qcom/sm8350-sony-xperia-sagami-pdx215.dts | 13 ++ .../dts/qcom/sm8350-sony-xperia-sagami.dtsi | 132 ++++++++++++++++++ 4 files changed, 166 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami-pdx214.dts create mode 100644 arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami-pdx215.dts create mode 100644 arch/arm64/boot/dts/qcom/sm8350-sony-xperia-sagami.dtsi