@@ -143,10 +143,6 @@
#define PLLCX_MISC2_DEFAULT 0x30211200
#define PLLCX_MISC3_DEFAULT 0x200
-#define PMC_SATA_PWRGT 0x1ac
-#define PMC_SATA_PWRGT_PLLE_IDDQ_VALUE BIT(5)
-#define PMC_SATA_PWRGT_PLLE_IDDQ_SWCTL BIT(4)
-
#define PLLSS_MISC_KCP 0
#define PLLSS_MISC_KVCO 0
#define PLLSS_MISC_SETUP 0
@@ -863,24 +859,11 @@ static int clk_plle_training(struct tegra_clk_pll *pll)
u32 val;
unsigned long timeout;
- if (!pll->pmc)
- return -ENOSYS;
-
/*
* PLLE is already disabled, and setup cleared;
* create falling edge on PLLE IDDQ input.
*/
- val = readl(pll->pmc + PMC_SATA_PWRGT);
- val |= PMC_SATA_PWRGT_PLLE_IDDQ_VALUE;
- writel(val, pll->pmc + PMC_SATA_PWRGT);
-
- val = readl(pll->pmc + PMC_SATA_PWRGT);
- val |= PMC_SATA_PWRGT_PLLE_IDDQ_SWCTL;
- writel(val, pll->pmc + PMC_SATA_PWRGT);
-
- val = readl(pll->pmc + PMC_SATA_PWRGT);
- val &= ~PMC_SATA_PWRGT_PLLE_IDDQ_VALUE;
- writel(val, pll->pmc + PMC_SATA_PWRGT);
+ tegra_pmc_clear_plle_iddq();
val = pll_readl_misc(pll);
Tegra PMC has PLLE IDDQ programming to bring the PLLE pads out of DPD idle state through software by overriding the hardware control. Currently Tegra clock driver programs Tegra PMC registers directly for enabling software override and to bring PLLE pads out of DPD idle state. With this, when Tegra PMC is in secure mode, any direct PMC register access from non-secure world will not go through. This patch updates Tegra clock driver to use Tegra PMC helper function to clear PLLE IDDQ through software control that does PMC programming using tegra_pmc_writel and tegra_pmc_readl which supports both secure mode and non-secure mode PMC access. Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com> --- drivers/clk/tegra/clk-pll.c | 19 +------------------ 1 file changed, 1 insertion(+), 18 deletions(-)